Loading ...
Loading ...
iii
LAUNCH
Professional 909E User Manual
• Keep this tool dry, clean, free from oil/water or grease. Use a mild detergent
on a clean cloth to clean the outside of the tool, when necessary.
• Please use the 5 V DC power adaptor to charge this tool. No responsibility
can be assumed for any damage or loss caused as a result of using power
adaptors other than the right one.
FCC Statement
:
Any Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Creader Professional 909E (FCC ID: XUJCRP349) has been evaluated to meet general RF
exposure requirement. The highest reported SAR value is 0.58W/kg. This device was tested
for typical body-worn operations with the back of the handset kept 0mm from the body.
The use of accessories that do not satisfy these requirements may not comply with FCC RF
exposure requirements, and should be avoided.
Hereby, Launch Tech Co., Ltd. declares that this Professional Diagnostic Tool (Model Creader
Professional 909E) is in compliance with the essential Requirements and other relevant
provisions of Radio Equipment Directive 2014/53/EU.
Operation frequency and Max. RF output power:
WiFi 802.11b/g/n(2.4G): 2412-2472MHz, 18.92dBm;
The RF frequencies can be used in Europe without restriction.
Loading ...
Loading ...
Loading ...