Loading ...
Loading ...
Loading ...
Frame Cover
stop the engine by removing the ignitionkey and loosen
the plastic wing knobs found on either side of the
discharge chute. Pivot the chute upward or downward
before re-tightening the wing knobs.
AugerControl
Refer to Auger Control Test in the Operating Section to
adjust the auger control.
SkidShoes
The space between the shave plate and the ground can
be adjusted. See Figure 19.
For close snow removal on a smooth surface, raise
skid shoes higher on the auger housing.
Use a middle or lower position when the area to be
cleared is uneven.
Figure 17
With the traction controlis released, there must be
clearance between the friction wheel and the drive
plate in all positions of the shift lever.See Figure 18.
With the traction control is engaged, the friction
wheel must contact the drive plate.
Friction
Wheel
Drive
_Gap
Figure 18
If adjustment isnecessary.
Loosen the jam nut on the traction control cable
and thread the cable in or out as necessary.
Retighten the jam nut to secure the cable when
correct adjustment is reached.
Reassemble the frame cover.
NOTE: If you placed plastic film under the gas cap, be
certain to remove # before operating.
ChuteAssembly
The distance snow is thrown can be adjusted by
changing the angle of the chute assembly. To do so,
15
Bolts Hex
Figure 19
WARNING: Do not operate this snow
thrower on gravel as loose gravel can be
easily picked up and thrown by the auger
causing injury to the operator and/or
damage to the snow thrower.
Adjust skid shoes by loosening the four hex nuts
and carriage bolts. Move skid shoes to desired
position.
Make certain the entire bottom surface of skid shoe
is against the ground to avoid uneven wear on the
skid shoes. Retighten nuts and bolts securely.
Carburetor
Minor carburetor adjustment may be required to
compensate for differences infuel, temperature,
altitude and load.
Refer to the separate engine manual, packed with
your unit, for carburetor adjustment information.
WARNING: If any adjustments need to
be made to the engine while the engine is
running (e.g. carburetor), keep clear of all
moving parts. Be careful of muffler, engine
and other surrounding heated surfaces.
Loading ...
Loading ...
Loading ...