Loading ...
Loading ...
Loading ...
To lubricate the link rod
1. There are 2 grease nipples, one on each side of the
link rod. Lubricate with a grease gun until grease
comes out.
Troubleshooting
If you cannot find a solution to your problems in this
manual, speak to your Husqvarna service agent.
Problem Cause
The starter motor does not turn the
engine over
The parking brake is not applied. Refer to
To apply and release the parking
brake on page 20
.
The lift lever for the cutting deck is in mow position. Refer to
To lift the cut-
ting deck on page 17
.
The main fuse is blown. Refer to
To replace a fuse on page 28
.
The ignition lock is defective.
The connection between the cable and the battery is bad. Refer to
Battery
safety on page 13
.
The battery is too weak. Refer to
To charge the battery on page 28
.
The starter motor is defective.
The engine does not start when the
start motor turns the engine over
There is no fuel in the fuel tank. Refer to
To fill fuel on page 16
.
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburetor or fuel line (P 524).
There is dirt in the fuel line (P 524EFI).
40 242 - 003 -
Loading ...
Loading ...
Loading ...