Loading ...
Loading ...
Loading ...
4. Set the cutting height lever to the middle position.
5. Measure the distance between the ground and the
front and rear edges of the cutting deck. Make sure
that the rear edge is 4–6 mm (1/5 in.) higher than the
front edge.
To adjust the parallelism of the cutting
deck
1. Remove the front cover.
2. Loosen the nuts on the track rod.
3. Turn the track rod to extend it or make it shorter.
Extend the track rod to lift the rear edge of the cover.
Make the track rod shorter to lower the rear edge of
the cover.
4. Tighten the nuts on the track rod when the
adjustment is done.
5. Do a check of the parallelism. Refer to
To do a
check of the parallelism of the cutting deck on page
31
.
6. Attach the front cover.
To replace the V-belt on the cutting
deck
WARNING: Risk of crush injury. Use
protective gloves.
1. Remove the cutting deck. Refer to
To remove the
cutting deck on page 15
.
2. Open the lock for the track rod bolt.
3. Remove the 2 bolts that hold the lock bracket on the
cutting deck frame.
4. Remove the lock bracket and remove the cutting
deck frame.
5. Remove the 2 bolts on the cutting deck frame.
32
242 - 003 -
Loading ...
Loading ...
Loading ...