Loading ...
Loading ...
Loading ...
Quick Start Guide
7
EMX5 Owner’s Manual
Portable audio
player
Passive speakers
Power amplifier
NOTE
Normally, speakers are connected via
the [SPEAKERS A/B] jacks on the rear
panel. However, if a higher output level
is required, or if you want to add more
speakers, connect the speakers via a
power amplifier that is connected to
the [STEREO OUT] jack.
6. When connecting a condenser microphone, set the [PHANTOM
+48V] switch to the ON position ( ).
7. Turn on the power.
Switching order:
Instrument or audio device → Mixer [ ] (Power) switch
8. Set the [LEVEL] control for the channel that has the connected
device to the “ ” position.
9. Use the STEREO MASTER [LEVEL] control to adjust the overall
sound level.
10. If necessary, adjust the level balance of the connected
devices using the [LEVEL] controls for channels 1 to 11/12.
WARNING
When turning off the power, a loud and unpleasant noise may be generated by
the speakers. To prevent this, first turn off the Mixer [ ] (Power) switch, then
turn off the instrument or audio device.
t
Optimizing the volume settings
When the volume is too loud
Turn the [LEVEL] control to the minimum (zero). Set the [ MIC/ LINE] switch to
the “ LINE” position, and then slowly raise the [LEVEL] control until the desired
volume is reached.
When the volume is too soft
Turn the [LEVEL] control to the minimum (zero). Set the [ MIC/ LINE] switch to
the “ MIC” position, and then slowly raise the [LEVEL] control until the desired vol-
ume is reached.
Loading ...
Loading ...
Loading ...