Loading ...
Loading ...
Loading ...
Problem solving guide
67
Many malfunctions and minor faults that can occur in daily operation can be
corrected without contacting Miele. This will save you time and money because
you will not need a service call.
You can find information on how to remedy faults yourself at
www.miele.com.au/service or www.miele.co.nz/service.
Please note, however, that a call-out charge will be applied to unnecessary service
visits where the problem could have been rectified as described in these operating
instructions.
Fault messages shown in the display when a programme is
cancelled
Message Possible cause and remedy
Empty the container
or check the drain
outlet
The condensed water container is full or there is a
kink in the drain hose.
Open and close the door with the tumble dryer
switched on to clear the message. Or switch the
tumble dryer off and then on again.
Empty the condensed water container.
Check the drain hose.
Obstruction
detected. Untangle
laundry and restart.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. If
necessary, take out some of the laundry.
Switch the dryer off and back on.
Start a programme.
Fault F. If restart
fails, call Service.
There is no obvious cause.
Switch the dryer off and back on.
Start a programme.
If the programme terminates again with the same
fault message, then there is a fault. Contact Miele.
Loading ...
Loading ...
Loading ...