Loading ...
Loading ...
Loading ...
DJI Air 3
User Manual
©
2023 DJI All Rights Reserved.
43
[1] Before selecting POI for heading or gimbal tilt, make sure there are POIs in the ight route. If a POI is
linked to a waypoint, the heading and gimbal tilt of the waypoint will be reset to toward the POI.
[2] The zoom of the Start Point and the End Point cannot be set to auto.
All the settings except camera action can be applied to all the waypoints after selecting Apply to
All. Tap to delete the currently selected waypoint.
4. POI Settings
Tap POI on the operation panel to switch to POI settings. Use the same method to pin a POI
as used with a waypoint.
Tap the POI number to set the altitude of the POI and link the POI to waypoints.
Multiple waypoints can be linked to the same POI, and the camera will point toward the POI
during the Waypoint Flight.
5. Perform a Waypoint Flights
• Check the Obstacle Avoidance Action settings in the Settings > Safety page of DJI Fly before
performing a Waypoint Flight. When set to Bypass or Brake, the aircraft will brake and
hover in place if an obstacle is detected during the Waypoint Flight. The aircraft cannot
sense obstacles if the Obstacle Avoidance Action is disabled. Fly with caution.
• Observe the environment and ensure there are no obstacles on the route before
performing a Waypoint Flight.
• Make sure to maintain visual line of sight (VLOS) of the aircraft. Always be prepared
to press the ight pause button in case any emergency situation occurs.
• Tap GO, the aircraft will automatically switch to the camera selected in the flight
route parameters setting page. DO NOT switch to the other camera manually.
• When the remote controller signal is lost during ight, the aircraft will perform the
action set in On Signal Lost.
• When the Waypoint Flight is nished, the aircraft will perform the action set in End
of Flight.
a. Tap Next or
on the operation panel to enter the ight route parameters setting page
and check again. Users can change the Start Point if necessary. Tap GO to upload the
waypoint ight task. Tap to cancel the uploading process and return to the ight route
parameters setting page.
b. The waypoint flight task will be performed after being uploaded
.
The flight duration,
waypoints, and distance will be displayed on the camera view. The control stick input will
change the ight speed during a Waypoint Flight.
c. Tap
to pause the Waypoint Flight after the task begins. Tap to continue the
Waypoint Flight. Tap
to stop Waypoint Flight and return to the waypoint flight edit
status.
6. Library
When planning a Waypoint Flight, the task will be generated automatically and saved every
minute. Tap
on the left to enter Library and save the task manually.
Loading ...
Loading ...
Loading ...