Instruction Manual - Page 6

For 2022447525. Also, The document are for others Furrion models: FACR13SA-PS, FACR13SA-BL, FACR14SA-PS, FACR14SA-BL, FACR15SA-PS, FACR15SA-BL

Loading ...
Loading ...
Loading ...
5
New Opening
When no roof vent is available or another
location is desired, the following is
recommended:
For one unit installation - the air
conditioner should be mounted
slightly forward of center (front to
back) and centered from side to side.
For two unit installations, install one
air conditioner one third from the front
of the RV and the other air conditioner
two thirds from the front of the RV,
aligned in the center.
It is preferred that the air conditioner be
installed on a relatively flat and horizontal
roof section measured when the RV is
parked on a level surface.
NOTE: A 15° slant to either side or front
to back is acceptable for all units. If the
roof exceeds 15° please use an exterior
leveling shim to make air conditioner
level.
After the Location Has Been
Selected:
Check for obstructions in the area
where the air conditioner will be
installed.
Center Line
of Rooftop
Front
Roof Opening
18”
34⁄”
(884mm)
13⁄”
(345mm)
27⁄”
(700mm)
Keep this air flow area free of obstructions
Check the inside of the RV for
return air kit obstructions. (i.e. door
openings, room dividers, curtains,
ceiling fixtures, etc.) Allow 6”
(152mm) space from the opening to
account for any potential return air kit
obstructions.
Roof
Opening
19⁄”
(500mm)
19⁄”
(500mm)
2⁄”
(70mm)
19⁄”
(500mm)
19⁄”
(500mm)
6"
6"
Loading ...
Loading ...
Loading ...