Loading page 1...
Loading page 2...
Loading page 3...
Loading page 4...
Loading page 5...
Loading page 6...
Loading page 7...
Loading page 8...
Loading page 9...
Loading page 10...
10
Installation
Installing the Rooftop Unit
CAUTION
● The rooftop unit weighs
approximately 100 pounds (45
kg). To prevent back injury, use a
mechanical hoist when lifting or
moving the unit. Failure to obey this
warning could result in injury.
● Do not slide unit. It may damage the
gasket at the bottom of the rooftop
unit and cause leakage.
● Do not grasp the ventilation slots to
lift the rooftop unit up.
1. Grasp the bottom of two sides of the
unit, lift and position the rooftop unit
into the prepared opening using the
gasket at the bottom of the rooftop
unit as a guide. (Fig. 1)
Roof Opening
This Side is
Facing Forward
Fig. 1
This completes the outside installation of
the rooftop unit. Minor adjustments can
be done from inside of the RV if required.
Installing the Air
Distribution Box
(for FACT11MA-PS/
FACT11MA-PS models
only, same for both
ducted and non-ducted
models, sold separately)
The rooftop unit is fixed on the RV roof
using 4 long bolts through the mounting
frame from the interior of the RV ceiling.
1. Check the gasket alignment of the
rooftop unit inside the RV over the
roof opening and adjust as necessary
by lifting and moving slightly. (Fig. 2)
Roof Opening
Fig. 2
2. Reach up into the return air opening
and pull the rooftop unit electric cord
and 115VAC power cord down from
the cutout area for later connection.
(Fig. 3)
Roof Opening
115VAC
Power Cord
Rooftop Unit
Cable
Ceiling Thickness
Fig. 3
Loading page 12...
Loading page 13...
Loading page 14...
Loading page 15...
Loading page 16...
Loading page 17...
Loading page 18...
Loading page 19...
Loading page 20...
Loading page 21...