Loading ...
Loading ...
Loading ...
12
8. Peel to remove the release paper from
the PE foam, overlap the sticky side
over all gaps and compress to seal
and insulate the entire section. (Fig. 9)
PE Foam
Fig. 9
9. Remove the cable compartment
cover using a Phillips screw driver.
(Fig. 10)
Fig. 10
DANGER
Electrical Shock Hazard
● Disconnect power before servicing.
Failure to obey this warning could
result in death or serious injury.
● Provide grounding in compliance
with all applicable electrical codes.
Failure to obey this warning could
result in death or serious injury.
Loosen the cable clip on top of the
control box and let the 115VAC power
cord pass through the cable clip. Make
the 115VAC power supply connection
to the control box and ensure they are
properly insulated by using twist caps.
(Fig. 11)
NOTE: Always follow the color code
while connecting the cables.
Black - Hot
White - Neutral
Green/yellow - Ground
Fig. 11
10. Tighten the cable clip until the cable is
snapped tightly.
NOTE: Do not over tighten.
11. Fit all cables into the cable
compartment and tuck any excess
wires up out of the way. Tighten the
cover with screw. (Fig. 12)
Fig. 12
12. Connect the wires of the rooftop unit cable to
the control box. (Fig. 13)
− 115VAC Power Cord: Connect to
115VAC power source
115VAC Power
Cord
Rooftop Unit
Cable
Fig. 13
Loading ...
Loading ...
Loading ...