Craftsman 13953992 garage door opener

User Manual - Page 23

For 13953992.

PDF File Manual, 76 pages, Download pdf file

Loading ...
Loading ...
Loading ...
INSTALLATION STEP 10
Install the Lights and Lens
Install a 100 watt maximum light bulb in each
socket. The lights will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the lights wilt turn OFE
Insert bottom lens tabs into slots on chassis. Tilt
towards chassis to engage top tabs, then drop
down gently into place. (See illustration.)
To remove, depress both top lens tabs. Tilt lens
slightly outward and down, then pull out to clear
bulbs. Use care to avoid snapping off bottom lens
tabs.
NOTE: Use only standard fight bulbs. The use of
short neck or speciality light bulbs may overheat the
endpanel or light socket.
Top Lens Tab
Lens
Bottom
Chassis Slots
"--I N I ot
_00000_1
Top
Lens Tab
Bottom Insert Bottom
Chassis S_ot Lens Tabs First
INSTALLATION STEP 11
Attach the Emergency Release
Rope and Handle
Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot at
least 1" (2.5 cm) from the end of the rope to
prevent slipping.
Thread the other end of the rope through the hole
in the release arm of the outer trolley.
Adjust rope length so the handle is 6 feet (1.8 m)
above the floor. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal the
cut end with a match or lighter to prevent unravefing.
To prevent possible SERIOUSINJURYor DEATHfrom
a falling garage door:
- If possible, use emergency release handleto
disengage trolley ONLYwhen garage door is
CLOSED.Weakor broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
- NEVERuse emergency releasehandle unless garage
doorway is clear of persons and obstructions.
NEVERuse handle to pull door open or closed. If rope
knot becomes untied, you could fall.
E_ergs_n_Tre_eYseArm_ o<_ KOVoethand
23
Loading ...
Loading ...
Loading ...