Loading ...
Loading ...
Loading ...
6
2.4.3 OIP-D50D Decoder - Front Panel
NO
Item
Function Descriptions
①
Power Indicator
Display the status of the device. Please refer to 2.5 Description of
Indicator Display.
②
Connection
Indicator
Display the status of connection. Please refer to 2.5 Description of
Indicator Display.
③
USB 2.0 port
Connect to High Speed USB peripherals, such as USB disk.
<Remark> This does not support isochronous transmission of USB
access devices, such as digital cameras and external hard drives.
④
USB 1.1 port
Connect to Full Speed USB peripherals, such as a keyboard or a mouse.
<Remark> This does not support isochronous transmission of USB
access devices, such as digital cameras and external hard drives.
⑤
Reset Button
Press this button to restart the device (all settings will be retained).
⑥
Signal Source
and Image
Stream button
(1) Signal source: Press this button to select the signal source. You can
switch between HDMI and VGA image signals.
<Remark> Due to the requirements of streaming image and HDCP
encryption, the switching time will be at least 6 - 10 seconds.
(2) Image Stream: Press this button for 3 seconds to select the image
stream. You can switch between Graphic and Video image processing
modes.
Graphic mode: Optimizing high-resolution static images
Video mode: Optimizing full motion images
⑦
Channel or Link
button
(1) Channel +: Press this button to switch to the next available streaming
channel in the local network.
<Remark> If the device does not detect an available streaming channel,
its channel number will not be changed.
(2) Image Connection: Press this button for 3 seconds to enable or
disable image connection. When the video connection is disabled, the
display connected to the receiver will show the current IP address and
firmware version of the system.
(3) Resume the factory default setting: In the unplugged state, press and
hold this button, and then insert the power. When the POWER and LINK
indicators flash at the same time, it means the factory settings have been
restored (it takes 15~30 seconds). Then, release the button, and restart
the device.(including restoring the IP mode to Auto, the broadcast
channel to 0, and the cast mode to Multicast). The IP address of this
device will also automatically assign. The new address range is
169.254.XXX.XXX.
⑧
Channel or USB
Button
(1) Channel -: Press this button to switch to the previous available
streaming channel in the local network.
<Remark> If the device does not detect an available streaming channel,
its channel number will not be changed.
(2) USB Connection: Press this button for 3 seconds to enable or disable
the USB connection between the encoder and decoder (limited to
multicast).
<Remark> With multicast, only one decoder can enable the USB
connection with the encoder at a time, and other decoders on the same
Loading ...
Loading ...
Loading ...