Loading ...
Loading ...
Loading ...
10
3.2 Connection Setting
① Use an HDMI cable to connect the video source device to the HDMI input port on the
D50E encoder.
② Use an HDMI cable to connect the video display device to the HDMI output port on the
D50D decoder.
③ Use the network cable to connect the OIP network ports in the D50E encoder, D50D
decoder, and D50C controller to the network switch of the same domain, so that all OIP
devices are in the same local network.
④ Insert the transformer into the power ports of D50E encoder, D50D decoder, and D50C
controller and connect to the power. (If the network switch supports PoE (IEEE 802.3af)
technology, power can be obtained directly from the network switch.)
※ Steps ①-④ can extend the signal. You can enter the IP address of the encoder or
decoder on the browser to control the encoder or decoder individually. Or use the
WebGUI operation interface to control the video display device connected to the D50C
controller, which can simultaneously control all encoders and decoders currently
connected to the same local network.
You can also connect to other devices. Please refer to the following steps:
⑤ Connect the computer to the D50E encoder, and the controlled device to the RS-232
port of the D50D decoder. The computer can issue RS-232 commands to the controlled
device, and the controlled device will execute those commands.
⑥ Connect the IR emitter/receiver to the D50E encoder and D50D decoder to receive IR
signals from the remote control, and use the remote control to control the controlled
device.
⑦ The VGA source device can connect to D50E encoder and connect VGA display to
D50D decoder to output analog image and audio.
Loading ...
Loading ...
Loading ...