Loading ...
Loading ...
Loading ...
ENGLISH I 5
7. Use the crescent wrench and large hex key to tighten
the nut onto the bolt. Hold the head of the bolt
stationary with the hex key while using the crescent
wrench to tighten the nut. DO NOT OVERTIGHTEN
THE NUT! With some force, you should still be able
to move the steel washer underneath the nut with
your fi ngers. If the washer cannot be moved with your
fi ngers, slightly loosen the nut.
6. Connect the assembly to the bottom plate (B4). Place
one of the steel washers (E2) and the plastic cylinder
(E4) onto the bolt (E5). Then, insert the bolt through
the central hole in the bottom plate. Next, place the
Teflon washer (E3) over the plastic cylinder (E4) now
protruding from the bottom plate. Take the assembled
base and lower it onto the bottom plate so that the
plastic cylinder goes through the central hole in the top
plate. Now, place the remaining steel washer (E2) on the
end of the bolt protruding from the top plate. Thread the
nut (E1) onto the bolt. Go to Step 7 for instructions to
tighten the bolt.
D1
D2
D3
5
5. Attach the 3 feet (D1) to the bottom plate (B4) using
the feet screws (D2). Thread the screws fi rmly into the
predrilled pilot holes. Once installed, press the feet
screw covers (D3) onto the ends of the feet.
B4
B4
C1
C2
4
4. Attach the 3 tripod adapter discs (C1) to the bottom
plate (B4) using the tripod adapter screws (C2). Thread
the screws fi rmly into the predrilled pilot holes but do not
overtighten or you may strip the wood.
7
E1
E1
E2
E1
E4
B4
E3
E2
E5
6
B4B4
Loading ...
Loading ...
Loading ...