Loading ...
Loading ...
Loading ...
2. Press and hold the yaw trim right and the roll trim left buttons . Then power on
the radio, when the radio red light flashes quickly then release all the
buttons.Do not touch any of the radio levers at this time.
3. After the red light flashes quickly 2S, the red light changes to a slowly flashing
state. At this time, manually shake the rocker to the maximum range, and
then cycle two times.
4. Click the power switch button, the green light is always on,at the same
time,the buzzer will beep, Then the gimbal calibration is completed.
Goggles
Battery and Charging
The battery cartridge comes preinstalled with a 18650 battery. If a battery reinstall is
required please use caution making sure to install with the correct polarity. The
battery can be charged in the cartridge with a micro USB cable. When the battery is
charging the indicator light is green. The indicator light will turn red when charging is
complete.
Assembly
Minimal assembly is required for proper operation of the goggles. Follow the steps
below.
1. Attach the two supplied antennas by screwing them on to the SMA
connection point.
2. Place the battery cartridge in the sleeve on the backside of the head strap.
3. Feed the power lead through the loop on the top side of the head strap and
plug in the power lead to the port on the goggles. This will power the goggles.
Loading ...
Loading ...
Loading ...