Battery-Operated
Fabric Shaver
Model CLS1
Steaming Mitt
Model GPP1
Door Press Pad
Model GDPP1
DUAL VOLTAGE
FABRIC STEAMER
INSTRUCTION BOOKLET
For your safety and continued enjoyment
of this product, always read the instruction
book carefully before using.
MODEL GSC24
SAVE THESE
INSTRUCTIONS
IMPORTANT
FOR HOUSEHOLD USE ONLY
FILLING INSTRUCTIONS
1. Make sure the unit is unplugged.
2. Stand the unit on a table and grasp with
one hand.
3.Pull the water reservoir out, away from the
steamer body.
4. The rubber inlet cover is located on the top
of the water reservoir.
5. Open the inlet cover and fill the reservoir
with water. We recommend that you use only
distilled water (available at grocery stores),
as this will prevent mineral deposits in the
boiler that can reduce performance or clog
the water system.
6. Close the inlet cover and return the
reservoir to its proper position, making sure
that it snaps in place and is secure.
OPERATING
INSTRUCTIONS
1. Fill water reservoir with water (distilled
water is recommended). See directions at left.
2. Confirm the voltage available at each
location before using the appliance. Check that
the dual voltage switch on bottom of unit is in
the correct position for the voltage available.
For use in the U.S.A., the dual voltage switch
should be in the 120 volt position. For use in
several other countries, the voltage selector
switch may need to be slid to the 240 volt
position. An adapter plug may be necessary
when using this appliance in some foreign
countries. If so, plug the steamer into correct
adapter plug for your location and plug
assembly into electrical outlet.
3. Point the steamer head away from you
and anyone else in the room. Press the
Power Button. The Steam Button should light
up red and then turn green when steam is
ready (within approximately 35 seconds). The
garment steamer is now ready to use. Press
the Steam Button to release a continuous
flow of steam from the steam head.
4. Hold steamer by its handle while steaming
garments or while unit is hot.
5. Direct the flow of steam toward garment to
remove wrinkles.
6. To stop the flow of steam, press the Steam
Button again.
7. Press the round Steam Head Adjustment
Button on the hinge to unlock the steam head
for angle adjustment.
8. Press the Power Button to turn off.
9.
Unplug the device when it is not in use.
STEAMING TIPS
1. Hang your garment or fabric. NOTE: Avoid
using metal clothes hangers, if possible.
2. Pass the steam jets about an inch above
the fabric where the wrinkles are. It may
take a few passes to remove the wrinkles
completely.
3. CAUTION: When hanging garment on a
door while steaming, be careful not to
damage the door with steam.
4. First test unit on an inconspicuous area of
the item to be steamed, to ensure fabric can
tolerate the effects of steam. If there is no
evidence of damage, you can proceed to use
the steamer on that item.
5. When steaming, always keep the unit in
motion and about one inch from the surface
of the item being steamed to avoid potential
damage. Do not continuously hold steamer
over an area or let steamer jets directly touch
the fabric, as this as this can cause damage,
including shrinkage, melting, or color shift on
certain types of material.
6. In the case of heavier, durable fabrics,
such as wool coats or bedding, slower
passes with the steamer may be necessary
to achieve desired results.
7. After use, unplug steamer and empty
any remaining water from the tank to avoid
leakage.
KILLS 99.9% OF BACTERIA*
1. Position the garment steamer’s nozzle at a
minimum distance of 0.5 inch (1.3 cm) from
material to be treated.
2. Remain steaming in this position for 2
minutes, then move to the next area to be
treated and repeat.
*Bacteria reduction rate was measured after
exposing the tested samples to steam for 2
minutes at a ½-inch distance from the garment
steamer head. Testing was performed on E. coli.
CONAIR GARMENT
STEAMING ACCESSORIES
(sold separately)
LIMITED ONE-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option)
your unit free of charge for 12 months from
the date of purchase if the appliance is
defective in workmanship or materials.
To obtain service under this warranty, return
the defective product to the service center
listed, together with your purchase receipt.
California residents need only provide proof of
purchase and should call 1-800-3-CONAIR
for shipping instructions. In the absence of a
purchase receipt, the warranty period shall be
12 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS,
OR LIABILITIES, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, SHALL BE LIMITED
IN DURATION TO THE 12-MONTH DURATION
OF THIS WRITTEN, LIMITED WARRANTY.
Some states do not allow limitations on how
long an implied warranty lasts, so the above
limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESS
OR IMPLIED, WHATSOEVER.
Some states do not allow the exclusion
or limitation of special, incidental, or
consequential damages, so the above
limitation may not apply to you.
This warranty gives you specific legal rights,
and you may also have other rights, which
vary from state to state.
Service Center
Conair LLC
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
For information on any Conair
®
product, call
1-800-3-CONAIR or visit us on the web at
www.conair.com
Please register this product at
register.conair.com
©2022 Conair LLC
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
Made in China
22PA084143
IB-17710
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be taken,
including the following:
READ ALL
INSTRUCTIONS
BEFORE USING
DANGER –
Any appliance is
electrically live even when the switch is off.
To reduce the risk of death by electric shock:
1. Always unplug this appliance from the
electrical outlet immediately after using
and before cleaning.
2. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
3. Do not place in or drop into water or
other liquids.
4. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING – To reduce the risk of
burns, electrocution, fire, or injury to persons:
1. This appliance should never be left
unattended when plugged in.
2. This appliance is not a toy! Keep away
from children.
3. Close supervision is necessary when
this appliance is used by or near children
or individuals with certain disabilities.
Unsupervised use could result in fire or
personal injury.
4. Use this appliance only for its intended
use as described in this manual. Do not
use attachments not recommended by the
manufacturer. Attachments sold separately.
5. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly, or if it has been dropped,
damaged, or dropped into water. Do not
attempt to repair the appliance. Incorrect
reassembly or repair could cause a risk
of fire, electric shock, or injury to persons
when the appliance is used. Return the
appliance to an authorized service center
for examination and repair.
6. Keep the cord away from heated surfaces.
Do not allow cord to contact heated surfaces.
Do not pull or twist cord. Let appliance cool
completely before putting away. Loop cord
loosely around appliance when storing.
7. To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). As a safety feature,
this plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact
a qualified electrician. Do not attempt to
defeat this safety feature.
8. Never drop or insert any object into
any opening.
9. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
10. Do not handle plug with wet hands.
11. Surfaces of this appliance may be hot
when in use. Do not let heated surfaces
touch eyes or skin.
12. Do not place the steam nozzle directly on
any surface or on the appliance power cord
while it is hot or plugged in.
13. Unplug this appliance before filling
or emptying.
14. Do not operate steamer without properly
filling the water container with distilled water.
15. Never yank cord to disconnect from
outlet; instead, grasp plug and pull to
disconnect.
16. Burns could occur from touching hot
surfaces, hot water, or steam. Use care when
removing water reservoir or when you turn
a steam appliance upside down – there may
be hot water in reservoir. Always position
steamer with head away from you and any
other person when turning on.
17. To reduce likelihood of circuit overload,
do not operate another high-wattage
appliance on the same circuit.
18. Never steam clothes you, or someone
else, are wearing.
19. Do not hold hand in front of steam.
20. When emitting steam, appliance may
cause burns if it is used too close to the skin
or eyes, or if it is used incorrectly. To reduce
the risk of contact with hot water emitting
from the steam vents, test appliance before
use by holding it away from the body.
21. We recommend you do not use an
extension cord to operate this appliance. If
an extension cord is absolutely necessary, a
15 ampere-rated cord should be used. Cords
rated for less amperage may overheat. Care
should be taken to arrange the cord so that
the cord cannot be pulled or tripped over.
DUAL VOLTAGE
Be sure dual voltage selector is in correct
voltage position before operating. Before
plugging in, read the information about dual
voltage operation contained in this manual.
This appliance was set at the factory to
operate at 120 volts. Refer to the instructions
below for conversion to 240 volt operation
This is a 120/240V dual voltage appliance
and may be used in the U.S.A. and abroad
without an electricity converter. For use
in the U.S.A., the voltage selector switch
should be in the 120 volt position. For use in
several other countries, the voltage selector
switch may need to be placed in the 240
volt position. Confirm the voltage available at
each location before using the appliance. An
adapter plug may be necessary when using
this appliance in some foreign countries. If
so, plug the steamer into correct adapter
plug for your location and plug assembly into
electrical outlet.
FEDERAL COMMUNICATIONS
COMMISSION NOTICE
WARNING: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) This device must
accept any interference received, including
interference that may cause undesired
operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
SUPPLIER’S DECLARATION
OF CONFORMITY
Brand: Conair
®
Model No.: GSC24
Description: Handheld Steamer
Responsible Party: Conair LLC,
1 Cummings Point Road, Stamford, CT 06902
(203) 351-9000
Standards: FCC Part 15 Subpart B, ANSI
C63.4-2014
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and (2) This device must
accept any interference received, including
interference that may cause
undesired
operation.
DATE OF ISSUE: 05/26/2022
Power Button
Steam Button
Steam Head
Adjustment
Button to
adjust head
position
Power Cord
Steam Head
Removable
Water Reservoir
Dual Voltage switch under
bottom of steamer
GETTING TO KNOW YOUR STEAMER
Loading ...
