BRITAX E1C903Y One4life Convertible Car Seat, 10 Years Of Use From 5 To 120 Pounds, Converts From Rear-facing Infant Car Seat To Forward-facing Booster Seat, Machine-washable Fabric, Iris Onyx

User Manual - Page 13

For E1C903Y.

PDF File Manual, 52 pages, Read Online | Download pdf file

E1C903Y photo
Loading ...
Loading ...
Loading ...
11
The Lower Anchors and Tethers for Children or LATCH,
is a system available on this child restraint that oers an
alternative to vehicle seat belt installation methods. The
figure above shows typical locations for lower anchors
and tether anchors in a vehicle. See pages 2 - 3 for
LATCH components on this child restraint.
Check your vehicle owner’s manual to learn if it is equipped
with LATCH, the maximum weight rating for the lower
anchors, tether anchors capacities, and information on the
lower anchor locations and designated seating positions
available for use with this child restraint.
Tether anchor locations vary
from vehicle to vehicle. Check
your vehicle owner’s manual
and look for the tether anchor
symbol shown in the diagram
to help identify where the top
tether anchor point is located in
your vehicle.
Or
Or
Vehicle Seat
Head Restraint
Vehicle Seat
Belt Retractor
Lap-Shoulder
Vehicle Seat Belt
Seat Belt Buckles
Frontal Air Bag
Vehicle Seat
Top Tether
Anchors
LATCH
Lower Anchors
Using the Lower Anchors and Tethers for Children (LATCH)
Overhang from Vehicle Seat
Harness Mode
It is important that the base of the child restraint rests
completely flat on the vehicle seat with no side overhang.
It is permissible to allow up to 3 in. (7.5 cm) of the base to
hang over the front edge of the vehicle seat. If the vehicle
seat does not allow enough of the child restraint base to
make contact, adjust the recline angle to a more upright
position. Not doing so could cause the child restraint to not
perform as intended.
IMPORTANT: Car seat base MUST be at on vehicle seat
and MUST be parallel to vehicle seat.
Booster Mode
Overhang is not allowed in BOOSTER mode. In BOOSTER
mode, the base of the child restraint must fit completely on the
vehicle seat.
Loading ...
Loading ...
Loading ...