Loading ...
Loading ...
Loading ...
www.insigniaproducts.com
24
Before you begin using your fire table
Operation checklist
For a safe and pleasant experience with your fire table, we suggest that you review this checklist whenever you use it.
1 I am familiar with this entire User Guide and understand all precautions noted.
2 All components are properly assembled, intact, and operate normally.
3 No alterations have been made to your fire table.
4 All gas connections are secure and leak free.
5 There is no excessive wind in the area of your fire table.
6 Your fire table is outdoors (outside any enclosure) and stable, on a hard and level surface.
7 There is adequate fresh air ventilation.
8 There is no gasoline or other flammable liquids or vapors in close proximity to your fire table.
9 Your fire table is located away from windows, air intake openings, sprinklers, and other water sources.
10 The sides, back, and front of your fire table are at least 24 in. (61 cm) from any combustible materials.
11 All persons in the area have been alerted to the hazards of high surface temperatures and to stay away from your fire
table to avoid burns or clothing ignition.
12 Young children should be carefully supervised when they are close to your fire table.
13 Any guard or other protective device removed for servicing has been replaced prior to operating your fire table.
14 The control compartment, burner, and circulating air passageways of your fire table are clean and free of spider webs,
insect nests, and other debris.
Before turning on the gas
• Make sure that the surrounding areas are free of combustible materials, gasoline, and other flammable vapors or
liquids.
• Make sure that there are no obstructions to air ventilation.
• Make sure that all gas connections are tight and there are no leaks.
• Make sure that the gas tank cover is clear of debris.
• Make sure that any component removed during assembly or servicing is replaced and fastened prior to starting.
Before lighting your fire table
• Inspect your fire table before each use and have a qualified service person check at least annually.
• If you are relighting a hot fire table, always wait at least five minutes.
• Inspect the visible portion of the hose before each use. If the hose leaks, you must replace it prior to operation. Only use
the replacement hose assembly specified by the manufacturer.
• You must use the pressure regulator and hose assembly supplied with your fire table. Only use replacement pressure
regulators and hose assemblies specified by the manufacturer.
WARNING: CARBON MONOXIDE HAZARD
For outdoor use only. Never use inside a house, or other unventilated or enclosed areas. Your fire table consumes air (oxygen). Do not
use in unventilated or enclosed areas to avoid endangering your life.
WARNINGS:
• Very hot while in operation!
• Never lean over your fire table while in use.
• Do not touch the tile of the spark guard while your fire table is in operation. Wait until your fire table has cooled down after use.
• Failure to comply with these instructions may result in serious bodily injury.
CAUTION:
• Do not attempt to operate until you have read and understand all Important Safety Information in this manual, all assembly is
complete, and leak checks have been performed.
• This appliance shall be used only in a well-ventilated space and shall not be used in a building, garage, or any other enclosed area.
• An appliance may be installed with shelter no more inclusive than:
• With walls on all sides, but with no overhead cover.
• Within a partial enclosure which includes an overhead cover and no more than two side walls. These side walls may be parallel, as
in a breezeway, or at right angles to each other.
• Within a partial enclosure which includes an overhead cover and three side walls, as long as 30% or more of the horizontal
periphery of the enclosure is permanently open.
Loading ...
Loading ...
Loading ...