Loading ...
Loading ...
Loading ...
16
LIGHTING INSTRUCTIONS
SAFETY PRACTICES AND PRECAUTIONS
WARNING
Read the ‘User Manual/Installation Instructions carefully
and completely before using your grill or grill accessory
to reduce the risk of fi re, burn hazard or other injury.
Ensure that burner ties and all packing materials are
removed before lighting any new accessory.
REMOVE ALL
SHIPPING TIES
AT EACH NEW SEASON
At the start of each new grilling season you should
remove the cooking grates and check the burners,
venturis, orifi ces and valves for obstructions.
Spiders and insects often nest in these areas of the
acces sory and can disrupt air fl ow, causing damage to the
acces sory and personal injury.
Also, check all hoses and fi ttings for damage, abrasion,
wear and tear and repair, if necessary, before turning the
gas on.
The 4/11 gas pressure regulator, Lynx part number 30781
supplied with the unit must be used for natural gas, or
LP supplied from a bulk storage system. The regulator is
factory preset, and convertible for either natural or LP
gas.
If connection to a Type 1, 20 lb LP cylinder is required, a
LP gas pressure regulator and hose assembly is required
and
it must be the type specifi ed by Lynx. When a LP gas
pressure regulator and hose assembly is used, the 4/11
regulator must be removed to prevent over-regulation.
Leak check all connections with a soap and water solution
before operating the burners. Turn all knobs to OFF and
SLOWLY turn on the gas supply valve. Do not use any grill
or side burner if you smell gas.
PURGING THE GAS LINES
You should purge the gas line of air before attempting to
light the grill accessory.
1. Make sure all grill controls are in the "OFF" position.
2. Slowly turn on the main gas supply.
3. Push in the control knob for the burner furthest from
the fuel source. Using the burner furthest from the
fuel source will completely purge the lines. It will take
several seconds for the burner to light.
4. Hold the knob ON for about 20 seconds to allow the
air in the system to purge and the burner to light
5. Wait at least 5 minutes after shutting o the control
before attempting to light the burners.
LIGHTING INSTRUCTIONS
1. Remove burner cover completely. Do not attempt to
light any burner with the cover in place
2. Ensure all knobs are in the OFF position. Test the
ignition system by pressing in the burner control knob
and looking and listening for the clicking sound of
the igniter. If no spark is visible and no clicking sound
is heard, proceed with match-lighting or refer to the
trouble shooting section.
3. Turn on the main gas supply and purge if needed.
4. Push in and turn the burner control knob to the LITE
position and hold for 5 seconds.
5. If burner does not light, turn knob to OFF, wait 5
minutes to allow gas to dissipate and repeat step 4
above
MATCH LIGHTING
Using a paper match or a utility lighter, hold a fl ame over
the burner ports while you push and turn the control knob
of the corresponding burner to the “lite” position. Keep
your face as far away from the burner as possible.
If the burner does not light in 5 seconds, turn the knob o
and wait 5 minutes before attempting again.
Read the ‘User Manual/Installation Instructions’ carefully
and completely before using your accessory to reduce the
risk of fi re, burn hazard or other injury.
Loading ...
Loading ...
Loading ...