Loading ...
Loading ...
Loading ...
10
GAS CONNECTIONS (con’t)
LP GAS
LP cylinder with type 1 valve connection
If the accessory is not teed o the grill, it will require
a regulator either for the LP cylinder or permanently
plumbed LP connections, such as those in line with a bulk
cylinder.
When using the 4/11 regulator you must ensure that it is
set for the proper fuel type. This is done by removing
the regulator cap and gasket and looking at the bottom
of the plunger to see what fuel type is visible. This is the
regulator fuel setting. NAT is for natural gas and LP is for
propane gas. The LP setting can be further identifi ed by
the large diameter disk on the bottom of the plunger. To
change from one gas to the other simply push the plunger
to the side to snap it out of the cap, turn the plunger so
it reads the desired gas type on the bottom, and push
the plunger until it snaps back into place in the cap then
replace the cap into the regulator.
When exchanging your cylinder for a refi ll, exchange
only for a Type 1 2016 cylinder with an over-fi ll protection
device.
Never use a cylinder with a damaged valve.
A dented or rusty LP cylinder may be hazardous and
should be avoided. If in doubt, have it checked by your LP
supplier.
Always check for leaks after every LP cylinder change.
Always shut o the LP-gas supply at the cylinder when
the accessory is not in use.
Cylinders must be stored outdoors in a well-ventilated
area out of the reach of children. If your accessory is
stored indoors, the LP cylinder must be stored outside.
LP CONNECTIONS
Make sure the LP cylinder valve is fully closed. It is
possible for the valve to be open without releasing gas
but, as soon as you start connecting the regulator, gas will
leak from the connection.
Insert the regulator inlet into the cylinder valve and turn
the black coupler clockwise until the coupler is hand tight.
Do not over-tighten this connection.
To disconnect the coupler, fi rst make sure the main
cylinder valve is turned o . Grasp the coupler and turn
counter clockwise. Always leak-test the connection after
refi lling or exchanging LP cylinders.
GAS CONVERSION KITS
Gas conversion kits are available from Lynx Grills to
allow the burner accessory to operate on either Natural
Gas or LPG. These kits should be installed by a qualifi ed
technician.
Loading ...
Loading ...
Loading ...