Loading ...
Loading ...
Loading ...
13
TESTING THE INSTALLATION
LEAK TEST PROCEDURE:
• Create a soapy solution of 1 part soap and 3 parts water.
• Confi rm that all control knobs are in the o position.
• Turn on the fuel supply. For natural gas, turn the valve
handle 1/4 turn to align with the gas fl ow.
• For L.P., turn the cylinder valve knob counter clockwise
one full rotation.
• Apply the soap solution generously by paint brush or
squirt bottle on all connections and fi ttings.
• If bubbles appear to “grow” on any of the connections,
you have a gas leak. IMMEDIATELY turn o the gas
supply..
FIXING A GAS LEAK
• Shut o the gas supply
• Turn all grill controls to the “ON” position to purge the
grill of any gas build-up, then turn the controls back
“OFF”.
• Wash o the soapy solution with cold water and dry.
• Tighten the loose joint, or replace the faulty part with
manufacturer-recommended replacement parts.
• DO NOT attempt to repair the L.P. cylinder valve if it is
damaged. The only way to safely resolve a damaged
cylinder is to REPLACE IT.
• Repeat the leak test to ensure that no leaks are present
DANGER
TO PREVENT FIRE OR EXPLOSION HAZARD, DO NOT SMOKE OR
ALLOW ANY POTENTIAL SOURCE OF IGNITION
(
SPARKS, ELECTRICAL
ARCING, ETC
)
IN THE AREA WHILE PERFORMING A LEAK TEST. LEAK
TESTS SHOULD BE CONDUCTED OUT-DOORS ONLY. NEVER CON
-
DU
C
T A LEAK TE
S
T U
S
ING FIRE
O
R FLAME
.
Before turning the gas supply on, check for proper installation using the following test:
1. Plug the transformer back into the receptacle.
2. Push in the gas control knob on your accessory and watch the igniter spark.
3. Turn on the light switch on the grill. Both the grill and the grill accessory lights should operate together. This indicates a
proper assembly.
4. Turn the gas on to all appliances.
5. Perform a leak test if you have not done so since plumbing the unit.
6. Check all burners for proper ignition. Refer to the Lighting Instructions for Side Burners.
Loading ...
Loading ...
Loading ...