Loading ...
Loading ...
Loading ...
18
1. Toggle to the right to enter OSD
Menu Screen.
2. Toggle to the up or down to select
main menu [PIP / PBP], then toggle
to the right to conrm.
3. Toggle to the up or down to select
[PIP / PBP Mode], then toggle to the
right.
4. Toggle to the up or down to select
[PIP], [PBP], then toggle to the right
to conrm your selection
.
5. Now you can move backward to set
the [PIP / PBP Input], [PIP Size], [PIP
Position] or [Swap].
Toggle to the right to conrm your
selection.
MultiView in OSD menu
• PIP / PBP Mode: There are two
modes for MultiView: [PIP] and
[PBP].
[PIP]: Picture in Picture
Open up a sub-window
of another signal source.
B
A (main)
When the sub source is
not detected:
B
A (main)
[PBP]: Picture by Picture
Open up a sub-window
side-by-side of other
signal sources.
BA (main)
When the sub source is
not detected.
A (main)
Note
The black strip located on the top
and the bottom of the screen is for
measuring the correct aspect ratio when
in the PBP mode. If you expect to see full-
screen, adjust your device's resolutions
to pop-up attention resolution and you
will able to see 2 devices' source screen
project to this display without black
strips. It is important to note that the
analog signal is not supported on full
screen in PIP mode. No support both
main source and sub source above the
4K 100Hz at the same time.
• PIP / PBP Input: There are different
video inputs to choose from as the
sub-display source: [HDMI 1], [HDMI
2], [DP], [USB C].
Please refer to the table below for
compatibility of the main/sub-input
source.
SUB SOURCE POSSIBILITY (xl)
Inputs
HDMI 1 HDMI 2
DisplayPort
USBC
MAIN
SOURCE
(xl)
HDMI 1
● ● ● ●
HDMI 2
● ● ● ●
DisplayPort
● ● ● ●
USBC
● ● ● ●
PIP Size: When PIP is activated, there are
three sub-window sizes to choose from
[Small], [Middle], and [Large].
B
A (main)
Small
Middle
Large
Loading ...
Loading ...
Loading ...