Loading ...
Loading ...
Loading ...
Pyrolysis
The oven is equipped with a pyrolyser cleaning system,
which destroys food residues at high temperature. The
operation is carried out automatically by means of the
programmer. The resulting fumes are rendered "clean" by
passing over a Pyrolyser wich starts as soon as cooking
begins. As very high temperatures are required by the
Pyrolyser, the oven door is fitted with a safety lock. The
pyrolyser can be stopped at any time. The door cannot be
opened until the safety lock is displayed.
NOTE : If a hob has been fitted above the oven, never use
the gas burners or the electric hot-plates while the
Pyrolyser is working, this will prevent the hob from
overheating.
TWO PYROLYTIC CYCLE are pre-set:
Pyrolitic Self Clean Eco: Cleans a moderately stained
oven. Operates for a period of 90 minutes.
Pyrolitic Self Clean : Cleans a heavily stained oven.
Operates for a period of 120 minutes.
Never use commercially available cleaning products on a
Pyrolytic oven!
Tip : Carrying out Pyrolytic cleaning immediately after
cooking allows you to take advantage of residual heat,
thus saving energy.
Before executing a pyrolytic cycle:
•Remove all the accessories from the oven because they
are not able to tolerate the high temperatures used
during the pyrolytic cleaning cycle ; in particular
removing grids, side racks and the telescopic guides
(refer to the chapter REMOVING GRIDS AND SIDE
RACKS) .
•Remove any large spillages or stains as it would take too
long to destroy them. Also excessively large amounts of
grease could ignite when subject to the very high
temperatures of the Pyrolytic cycle.
•Close the oven door.
•Excess spillage must be removed before cleaning.
• Clean the oven door;
• Remove large or coarse food residues from the inside
of the oven using a damp sponge. Do not use
detergents;
• Remove all accessories and the sliding rack kit (where
present);
• Do not place tea towels.
Using the pyrolitic cycle:
1- Tap icon to select the cleaning functions (d) and, using
the navigation buttons, choose the preferred pyrolitic
cycle.
2- It is possible to defer the start time of the pyroclean
cycle by changing the END time via the programmer.
3- After few minutes, when the oven reaches a high
temperature, the door locks automatically. The pyroclean
cycle can be stopped at any time by pushing On/Off
button.
4- Once the pyroclean cycle is finished, the pyrolysis will
switch off automatically.
EN 23
Hydro Easy Clean
300 ml
The Hydro Easy Clean procedure uses steam to help remove remaining fat and food particles from the
oven.
1. Pour 300 ml of water into the Hydro Easy Clean container at the bottom of the oven.
2. Select the dedicated function (d1).
4. Allow the program to operate.
5. After the cycle, allow the oven to cool down.
6. When the appliance is cool, clean the inner surfaces of the oven with a cloth.
Warning: Make sure that the appliance is cool before you touch it.
Care must be taken with all hot surfaces as there is a risk of burns. Use distilled or drinkable water.
Loading ...
Loading ...
Loading ...