Loading ...
Loading ...
I(.) I(.)@
L
I(Q)@
-.,/
3. Attach hood to rough-in plate with two screws and
nuts. Install one lock nut on each vertical adjustment
stud at top of hood.
IN STALL DOO R ASSE M BLY
i
FOR UNDER,SOFFIT INSTALLATIONS ONLY: Cut 5/16"
off top edge of wood frame for clearance.
I (J)
1, Attach wood frame using ten screws. Bottom edge of
frame should be 1/8" below bottom edge of metal
frame.
2. Mount cabinet doors to wood frame using same
hardware as rest of cabinetry.
0 0
(E)_) (F)_
1C13==_=_=====_
|
I
d OR
I
4. Secure spacer brackets to wall. Use two screws and
washers or two toggle bolts and washers as ap-
propriate.
5. If ducting horizontally, re-install duct elbow inside of
hood. Tape all duct connections.
I
(G)
ADJUSTINGWHEEL
\
3. Install frame assembly onto hood. Attach slides with
four lock nuts, Hood opening tension may be adjusted
by rotating adjusting wheels.
4. Center and flush-u p frame with cabinets. Loosen and
re-tighten hood and rough-in plate mounting screws
as necessary.
5. Reinstall blower compartment cover and baffle plate.
NOTE: Door may not close flush with cabinets unless
baffle plate is re-Installed correctly.
6. Plug in powercord. Install an F2OT12 fluorescent tube.
Turn on power and check operation.
Loading ...
Loading ...
Loading ...