Loading ...
Loading ...
Loading ...
19
4. Securely fasten the oven to the cabinet using the
#8-14 x 3/4" (1.9 cm) screws provided.
Insert the screws through hole in black trim aligning with hole
in oven frame. Do not overtighten screws.
A. Oven frame
B. Side trim hole
C. Side trim piece
5. The bottom vent trim and bottom vent shield are shipped in
the foam packing at the top of the oven.
Tall bottom vent shield are used when the oven is installed
with the feet in the tall position. Please contact service for one
to be shipped to you free of charge.
■ Align vent tab (B) with oven frame (A) as shown.
■ Using one #8-18 x 3/8" (9.5 mm) screw (C) on each side of
the shield tab (B), fasten the vent securely to the oven
frame (A).
A. Oven frame
B. Shield tab
C. #8-18 x 3/8" (9.5 mm) screws
■ Fasten the bottom vent trim securely to the oven frame (A).
A
B
C
C
B
A
6. After the bottom vent shield is installed.
■ Align the bottom vent trim tab (B) with the oven frame (A)
as shown.
■ Using one #8-18 x 3/8" (9.5 mm) screw (C) on each side
of the trim tab (B), align the top edge of the bottom vent
trim tab (E) with the hinge receiver edge (D) as shown.
A. Oven frame
B. Trim tab
C. #8-18 x 3/8" (9.5 mm)
screw
D. Hinge receiver edge
E. Bottom Vent Trim Tab
top edge
7. Replace the oven racks.
8. Replace the oven door. See the “Replace Oven Door(s)”
section.
9. Check that the door is free to open and close. If it is not,
repeat
the removal and installation procedures. See the
“Prepare Built-In Oven” section.
10. Repeat for lower oven door.
IMPORTANT: For proper oven operation, check that the gap
between bottom of the door and bottom vent trim is at least
1/4" (6.4 mm).
11. Reconnect power.
12. The display panel will light and boot up.
13. If the display panel does not light, reference the Warranty.
14. If F9E0 error code is encountered upon powering up the
unit, the appliance is wired incorrectly at the Junction Box or
Electrical Panel. Contact a qualified electrician to verify the
home electrical supply and the hardwire connection at the
Junction Box or Electrical Panel (See the Electrical
Connection Options section).
A
C
B
D
B
E
Loading ...
Loading ...
Loading ...