Loading ...
Loading ...
Loading ...
assembly
INSTALLING THE DEPTH STOP
1. Screw the THUMB SCREW partways into the DEPTH
POINTER.
2. Place the DEPTH POINTER SHOE inside the pointer.
3. Loosen QUILL LOCK HANDLE ... lower the quill
about two inches.
4. Slide the pointer and shoe onto the FEED STOP ROD
and tighten the thumb screw. Make sure the pointer is
positioned as shown,
5. Screw the FEED STOP NUT onto the top of the feed
stop rod.
6. Move the pointer upwards against the nut and tighten
the thumb screw.
7. Tighten QUILL LOCK HANDLE.
DEPTH
POINTER
DEPTH STOP
SHOE
FEED f
STOP
RAISING THE HEAD
1. Loosen the TABLE LOCK HANDLE.
2. Place a piece of WOOD on the table. USE THE packing
block.
3. Turn the CHUCK SLEEVE until the jaws are all the
way up inside the chuck.
4. Raise the table until the wood block touches the chuck
body.
5. Tighten the Table Lock Handle.
6. Locate the two clamps and bolts that you removed
from the paper tube when you first started unpacking
your drill press.
These parts make up the TABLE SUPPORT COLLAR.
Position the TABLE SUPPORT COLLAR underneath
the table and tighten the bolts,
7. Loosen the HEAD LOCK HANDLE.
8, Loosen the QUILL LOCK HANDLE.
HEAD LOCK
HANDLE
(RIGHT HAND SIDE)
TAE
COLLAR
QUILL LOCK
HANDLE
PIECE OF WOOD
Loading ...
Loading ...
Loading ...