Loading ...
Loading ...
Loading ...
assembty
NOTE: When using motors which have Y2" dia. shafts,
place the adapter sleeve (furnished with the motor) on
the shaft so that the slot in the sleeve is over the flat
spot.
4. Insert the shaft key (furnished with motor) into the
grooves in the shaft and pulley so that the end of the
key is even with the end of the shaft,
5. Tighten the set screw. Use a pair of pliers on the short
end of the set screw wrench for increased leverage.
1/2 IN. DIA.
MOTOR SHAFT
"_/}6 y 3/16 KEY
I
FLAT SPOT
EEVE
MOUNTING THE MOTOR
1, Position the motor mount as shown and place the
motor on top of it.
2, Find four 5/16 in.--18 x 1 in. CARRIAGE BOLTS, flat
wash_;rs and hex. nuts, among the loose parts.
3,
4.
Insert the bolts as shown ,.. install washers . .. screw
on nuts but DON'T TIGHTEN them:
RRIAGE BOLT
Using a 5/32 inch set screw wrench unscrew the PIVOT
screws asshown,
_ SCREW
10
Loading ...
Loading ...
Loading ...