Loading ...
Loading ...
Loading ...
Network Speed Dome & Positioning System User Manual
24
3. Click Set and set limits according to the prompt on the live image.
4. Optional: Click Clear to clear the limit settings of the selected mode.
5. Click Save.
6. Check Enable Limit.
Note
If you need to cancal all the set patrol paths, go to Configuration → PTZ → Clear Config, select
Clear All PTZ Limited, and click Save.
Result
The device can only move within the set region after saving the settings.
4.6 Set Initial Position
Initial position refers to the relative initial position of the device azimuth. You can set the initial
position if you need to select one point in the scene as the base point.
Steps
1. Go to Configuration → PTZ → Initial Position.
2. Move the device to the needed position by manually controlling the PTZ control buttons.
3. Click Set to save the information of initial position.
Call
The device moves to the set initial position.
Clear
Clear the set initial position.
4.7 Set Scheduled Tasks
You can set the device to perform a certain task during a certain period.
Steps
1. Go to Configuration → PTZ → Scheduled Tasks.
2. Check Enable Scheduled Task.
3. Select the task type and set the period. For setting the period, refer to Set Arming Schedule.
4. Repeat step 3 to set more than one scheduled tasks.
5. Set Park Time. During the set task period, if you operate the device manually, the scheduled
task will be suspended. When the manual operation is over, the device will continue to perform
the scheduled task after the set park time.
6. Click Save.
Loading ...
Loading ...
Loading ...