AR Blue Clean AR2N1 ASSEMBLY, CARE AND USE INSTRUCTIONS

Loading ...

OPERATING INSTRUCTIONS

Storage

• When your pressure washer session has been

completed, turn off the power switch. Unplug the

power cord from the outlet. Turn off the water supply.

Pull the trigger on the spray gun 2-3 seconds to drain

out the excess water and to release any remaining

water pressure. Do not allow the power washer to run

with no water owing through it.

• Remove high pressure hose from spray gun and

unscrew the other end of the high pressure hose from

the power washer.

• Remove lance from the gun. Place the gun in the

holster on the side.

• Make sure to discard any remaining detergent from

the tank. Residual chemical will stick to the container

which could become contaminated, and can cause

the detergent injector to clog and not function

properly. Flush the tank and nozzle head with clear

water to prevent clogging.

• Wind the power cord around the L-shaped hooks

located on the top of the machine.

• The pressure hose is stored on the hose hook located

on the back of the handle.

• DO NOT store the power washer where it is

exposed to freezing temperatures unless you use

an antifreeze designed for pumps. Store the power

washer indoors to prevent the water in the unit from

expanding under freezing conditions. When the

water freezes and expands, your power washer will

be damaged and become inoperable. Or, if storing

outdoors, it is recommended you use pump saver (not

included) to protect pumps.

CARE AND MAINTENANCE

OPERATING INSTRUCTIONSVERPUMP SAVER

Pump Saver is a product that protects and prolongs

the life of the pump. This will keep the internal parts

of the pump lubricated and protected from freezing

while being stored in ALL climates. It also assists with

protection from internal corrosion. The AR Blue Clean

part #is: PW64511(16oz. bottle). Order online at

www.arblueclean.com

Pump Saver Instructions

Turn unit off and disconnect the hose and gun before

adding pump saver. Unscrew threaded top from bottle

to remove seal and reattach threaded top to bottle.

Remove black cap from bottle.

1) Place top of pump saver bottle onto the garden hose

adapter previously installed on the pressure washer

inlet.

2) Secure pump saver bottle by turning in a clockwise

direction.

3) Turn the power on.

Note: Instructions on Pump Saver Bottle are generic and

not model specic.

4) Squeeze bottle to help it into the pump.

5) Turn power off when pump saver exits the machine’s

water outlet.

Loading ...

AR Blue Clean AR2N1 2050 Psi, 1.4 Gpm, 13 Amps Electric Pressure Washer

ASSEMBLY, CARE AND USE INSTRUCTIONS - Page 15