Loading ...
Loading ...
Loading ...
GPW2600 GAS PRESSURE WASHER
27
➢ RUST PROTECTION
1) Pour approximately one teaspoon of
engine oil through the spark plug hole and
pull the recoil starter slowly until you feel
increased pressure which indicates the
piston is on its compression stroke and
leave it in this position. This closes both the
intake and exhaust valves to prevent the
inside of the cylinder from rusting.
2) Cover the pressure washer and store it in a
clean, well ventilated and dry place. Ensure
storage area is at room temperature.
3) In addition, in order to prevent external parts
rust, please daub anti-rust oil to bolts and nuts of machine at least every
one year.
➢ PUMP ANTIFREEZE
If your pressure washer is subjected to freezing temperatures, damage
could occur. This type of damage is not covered under warranty. To avoid
possible damage, a small amount of antifreeze can be used.
1) Place the unit on its side with the water inlet facing upwards, pour 1/4 cup
of antifreeze into the water inlet.
2) Disconnect spark plug wire, and then pull recoil starter several times to
circulate the antifreeze in the pump system. Reconnect spark plug wire.
3) It is also important to make sure the wand and all hoses are
disconnected and drained of all water or they may burst.
When taking pressure washer out of storage, run water through the
system until it runs clear.
Engine
Oil
Spark
Plug
Loading ...
Loading ...