Loading ...
Loading ...
Loading ...
GPW2600 GAS PRESSURE WASHER
14
6, PREPARATION
1. OIL LEVEL
Check the oil level：
1) Turn the oil gauge dipstick counter
clockwise; remove it and clean it with a
clean cloth.
2) Fully reinsert the oil gauge dipstick and
pull it out to check the oil level.
3) If the oil level is halfway up the dipstick
or below, refill with SAE 10W-30 oil
through the dipstick hole until the oil
level reaches 3/4 up the dipstick or until
it reaches the bottom lip of the dipstick
hole as shown in illustration to the right.
Always use SAE 10W-30 oil.
Oil crankcase capacity: 0.6L
4) Reposition the oil gauge dipstick and tighten it by turning clockwise.
2. FUEL LEVEL
WARNING!
Pressure washer has no oil currently in crankcase! Operating the
unit without the correct amount of oil will damage the engine.
Always check the oil level before starting the engine, make sure the
pressure washer is on a level surface before checking oil level.
WARNING!
Make sure there is enough fuel in the fuel tank before operating.
This is a 4-cycle engine and does not require a gas/oil mixture.
There is a separate reservoir for gas and a separate reservoir for
oil.
Loading ...
Loading ...
Loading ...