Loading ...
Loading ...
Loading ...
14
2. Bin Control Installation
1) Remove the control box cover. Remove the 2thumbscrews securing insulation
panel(B), then remove insulation panel (B). See Fig. 3.
2) Disconnect the discharge hose from the pump motor, then disconnect the drain valve
drain hose and the overow drain hose.
3) Disconnect the pump motor connector from the back of the control box, then disconnect
the oat switch connector from the control board.
4) Remove the tape securing the bin control.
5) Remove the 2 thumbscrews securing the pump motor and oat switch assembly. See
Fig. 4.
6) Being careful not to pull the bin control cable, lift the bin control up out of the water tank.
Being careful not to snag the bin control or bin control cable, slide the water tank, cube
guide, and pump motor and oat switch assembly out of the icemaker.
Fig. 3
Thumbscrews
Insulation
Panel (B)
Pump Motor
Connector
Float Switch
Connector (Black)
Drain Valve
Drain Hose
Overow
Drain Hose
Discharge
Hose
Bin
Control
Tape
Bin Control Cable
Fig. 5
Bin Control Cable
Vinyl Hose
Grommet
Fig. 4
Thumbscrews
Water Tank
Cube Guide
Pump Motor
and Float
Switch
Assembly
Bin Control
Bin Control Cable
Rear Interior Wall
Bin Control
Thumbscrews
Standard Bin Control Mount Position
for Standard Dispenser Unit or Ice Storage Bin Application
7a) Standard Dispenser Unit or Ice Storage Bin Application: Secure the bin control to
the rear interior wall using the 2 thumbscrews on the rear interior wall. See Fig. 5. Route
the bin control cable vinyl hose through the grommet as illustrated. Do not leave any
slack in the ice drop zone.
Loading ...
Loading ...
Loading ...