Loading ...
Loading ...
Loading ...
Refer to the warranty in your Owner's Guide for our
toll-free service number and address. Please call or write ifyou
have inquiries about your range product and/or need to order
parts.
Waist-High Burner
(Self Clean Model_,
--Lower Oven Bottom
Removab e) _
If the flame is yellow in color, increase air shutter opening size. (See
"2" in illustration below.) If the flame is a distinct blue, reduce the air
shutter opening size.
To adjust loosen lock
screw (see "3"
illustration below),
reposition air shutter,
and tighten lock
screw. Replace oven
bottom.
Lock Screw
Air Shutter
Oven
Burner
Tube
®
Orifice
Hood
11. Air Shutter-Broil Burner (if equipped)
The approximate flame length of the broil burner is 1 inch (distinct
inner, blue flame). To determine if the broil burner flame is proper,
set the oven to broil. If the flame is yellow in color, increase air
shutter opening size (see "2" in illustration.) If the flame is a distinct
blue, reduce the air shutter opening size.
To adjust, loosen lock screw (see "3" in illustration), reposition air
shutter, and tighten lock screw.
12. Make Sure Range is Level.
Level the range by placing a level horizontally on an oven rack.
Check diagonally from front to back, then level the range by either
adjusting the leveling legs or by placing shims under the corners
of the range as needed.
13. After installation is complete, make sure all controls are
left in the OFF position.
Model and Serial Number Location
The serial plate is located under the lift-up cooktop. When ordering
parts for or making inquires about your range, always be sure to
include the model and serial numbers and a lot number or letter
from the serial plate on your range. Your serial plate also tells you
the rating of the burners, the type of fuel and the pressure the range
was adjusted for when it left the factory.
Before You Call for Service
Check to make sure the house fuses or circuit breakers for your
range are not blown or open. Refer to the Avoid Service Checklist
and operating instructions in your Owner's Guide. It may save you
time and expense. The list includes common occurrences that are
not the result of defective workmanship or materials in this
appliance.
Care, Cleaning and Maintenance - Refer to the Owner's Guide for
operating and cleaning instructions.
If removing the range is necessary for cleaning or maintenance,
shut offgas supply. Disconnect the gas and electrical supply. If the
gas or electrical supply is inaccessible, lift the unit slightly at the
front and pull out away from the wall. Pull only as far as necessary
to disconnect the gas and electrical supply. Finish removing the
unit for servicing and cleaning. Reinstall in reverse order making
sure to level the range and check gas connections for leaks. See
Anti-Tip instructions for proper anchoring instructions.
Gas Conversion
This range was adjusted for Natural or LP/Propane gas, as
specified on the serial plate.
Your regulator is in one of the two locations shown.
Do not remove the Pressure Regulator.
Pressure Regulator location
@@ @ @@
II II
Front Access
to Regulator:
Remove Kick Panel,
StorgareDrawe_ or
Warmer Drawe_
(See Owner's Guide
for Instructions).
If Equipped with
8toiler Drawer,
Open Broiler Drawe_
I
\
Pressure
Regulator
location at
rear of
range
la. Convertthe Pressure Regulator
Self-Cleaning Electric Ignition Models
a. Unscrew the cap from the pressure regulator. Be sure spring
stays in place.
b. Turn the cap to the desired setting (see illustration below).
c. Replace the cap of the regulator. The letters corresponding
with the type of gas being used should be visible on the
exposed end of the cap.
lb. Convert the Pressure Regulator
Non Self-Cleaning Electric Ignition Models
d CAP
HOLLOWTowARDsEND_1 _ 9 _ SOLIDTowARDsENDREGULa, TOR REGULATOR
FOR NATURAL GAS i FOR L,R GAS
Loading ...