Loading ...
Loading ...
Loading ...
Unstalling and Removing Previously
gnstalled Decorator Panels
In order to remove the decorator panels and replace
with new panels you need to remove the handles. A
T-20 Torx driver is needed.
Removing the Handles:
I. Loosen and remove the 2 screws in the Top Trim.
2. Loosen and remove the 2 screws in the bracket that
attach the Handle to the top of the Door.
3. Grip the Handle firmly and slide upwards. The
keyhole slots on the Handle slide off the buttons
on the Door'.
4. Open the Door and slide out the decorator panels.
Inserting the Door Panels:
Before installing the decorator panels, make sure they
have been routed out in the proper areas as shown in
the beginning of this section. Slide in the panels to
perform a trial fit before fastening down the Handle
and Top Trim.
installing the Handles:
Once the panels are fitted properly, install the Handle
and Top Trim.
i. Slide the keyhole slots on the Handle down onto
the buttons mounted to the face of the Door Slide
the Handle downward until the bracket at the top
of the Handle fits flush on the top of the Door.
2, Replace the two screws in the bracket that attach
the Handle to the top of the Door and tighten
the screws to 45 in-lbs torque_
3. Replace the Top Trim making sure it fits over the
Side Trim and that the locating tabs fit the inside
of the Handle profile.
4. Replace the Top Trim screws and tighten to 30
in-lbs torque.
Buttons
Top Trim Screws
Bracket Screws
Bracket
Slots
Slot
Loading ...
Loading ...
Loading ...