Loading ...
Loading ...
Loading ...
Care ¸and ¢Jeaning
Light Bulb Replacernent
Unplug refrigerator before changing a
light bulb.
Before replacing a burned-out light bulb, unplug
the refrigerator or turn off power at the circuit breaker
or' fuse box in order* to avoid contact with a live wire
filament. (A burned-out light bulb may break when
being replaced.) Note: Moving the control to the
OFF position does not remove power to the light
circuit.
Fresh Food Compartment---Upper Light
I. Pull off temperature control knobs.
Pin
2. Pull the bottom of the light shield down and
forward, then rotate the top up and off.
After replacing with same size bulb, reinstall light
shield.
Fresh Food Compartment_Lower Light
(on some models)
This light is located behind the top drawer or right
above the top drawer (depending on your model)°
J. Unplug the _efrigeratoro
2,
3_
,
.
If the light is behind the top drawer' you will need
to remove the drawer and the shelf above it,. To
remove the drawer see To Remove Storage Drawers
in the Shelves and Storage Drawers section.
To remove the shelf, first
remove any food on the
shelf. Then tilt the shelf up
at the fiont and lift it up
and out of the traclcs,
Grasp the bottom of
the light shield and pull it
forward and up,,
After replacing with same size bulb, replace the
shield. If you cannot locate the correct bulb, see
your dealer_
tf the light was behind the top drawer, you will need
to replace the drawer and the shelf above it.
To replace the shelfl raise the shelffront slightly and
engage the top hooks in the lowest large track slots,
Tl-ien lower the front of the shelf until it is level_
6. Plug the refrigerator back in.
Freezer Compartment
IJ
Remove shelf just below
light panel. (Shelf will be
easie_ to remove if ir is
emptied first.)
2_
Pull plastic light panel
towazd you, (It will bend
to flee tabs f_om grooves0
3. After' replacing with same
size bulb, reinstall panel and shelf,
22
Loading ...
Loading ...
Loading ...