Loading ...
Loading ...
Loading ...
Refrigerator lnstaUmation
Door Alignment
After leveling, make sure that
the doors are even at the top.
Make sure doors
are even at the top,,
k
L_
Uneven Doors
To make the doors
even, adjust the ftesh HingePin
food door_ Insert a Raise
3116" Allen wrench
into the bottom of
the hinge pin. Turn
the door adjusting 3116" Allen Wrench
screw to the right to
raise the door; to the left to lower it. (A nylon plug,
imbedded in the threads of the pin, prevents the pin
from turning unless a wrench is used.) After one or
two turns of the wrench, open and close the fresh food
door and check the alignment at the top of the doors.
Trim Kits and Decorator Panel mnstaHation
Some models are equipped with trim kits that allow you
to install door panels. You can order pre-cut black or
white decorator panels from your Seas Service Center, or
you can add wood panels to match your kitchen cabinets.
Panels Less Than i/4" (6 mm) Thick
When installing wood panels less than 1/4" (6 mm)
thick, you need to create a filler panel, such as 1/8"
cardboard, that will fit between the face of the door
and the wood panel. If you are installing the pre-cut
decorator panels; p_e-cut filler panels are included in
the ldto The combined thickness of the decorator or
wood panel and the filler panel should be 1/4" (6 rnm).
Care of Pre-Cut Panels
Clean these panels using an anti-static cleaner or a
mild detergent and water. (Look for anti-static cleaner
in electronic or computer departments.) Rinse
thoroughly and blot dry with a clean, damp cloth or
chamois_ Do not use paper towels to wash or dry the
panels. Do not use cleaners that contain solvents, such
as ammonia, because they can damage the panels.
Shallow scratches and abrasions can be corrected with
a good grade of hard automobile paste wax. Do not
use a cleaner!wax combination. The wax will fill in any
minor surface scratches and will help to maintain the
luster of the panels.. Apply the wax sparingly and buff
lightly with a clean, soft cloth using a circular motion.
3/4" (19 ram) or Raised Pane!
A raised panel design screwed or glued to a 1/4"
(6 ram) thick backing, or a 3/4" (19 ram) routed
board can be used. The raised portion of' the panel
must be fabricated to permit clearances of at least 2"
(51 mm) from the handle side for fingertip clearance°
Weight limitations for custom panels:
Fresh Food: 35 lb_ (16 kg) max,
Freezer Door: 25 lb, (11 kg) max,
1t4" (6 mm)
Thick Backing
2" (51
Clearance I I II I!
" °°'°s'°eilllli_
Appearance | _
_3/4 '; (!9 mt"
Re_'rigeralc
Door
Loading ...
Loading ...
Loading ...