Loading ...
Loading ...
Loading ...
Note
●
Auto Light is disabled when any one of
the conditions below exists.
ー
Alarm, timer alert, or other beeper
sounding
ー
Hand movement operation is in
progress
ー
Watch in the Compass Mode
ー
While a time signal receive
operation is in progress
●
Configuring the Auto Light Setting
You can enable or disable Auto Light as
required.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Pull out the crown.
This causes [CITY] to flash on the display
and the second hand to move to the
current Home City.
Second hand
Home City
Crown
3. Press (B) three times.
[ ] appears on the display with
[ON] or [OFF] flashing.
4. Rotate the crown to enable or disable the
Auto Light.
5. Push the crown back in to complete the
setting operation.
Note
●
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
●
Specifying the Illumination Duration
You can select either 1.5 seconds or three
seconds as the illumination duration.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Pull out the crown.
This causes [CITY] to flash on the display
and the second hand to move to the
current Home City.
Second hand
Home City
Crown
3. Press (B) four times.
[LIGHT] appears on the display with [1] or
[3] flashing.
4. Rotate the crown to select an illumination
duration.
[1]: 1.5-second illumination
[3]: 3-second illumination
5. Push the crown back in to complete the
setting operation.
Note
●
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Time Adjustment
Your watch can receive time calibration
signals and adjust its date and time setting.
Time Adjustment Using a
Time Signal
Overview
The watch’s time and day settings can be
configured in accordance with a received time
calibration signal.
Important!
●
In order to make it possible for the
current time setting to be adjusted
correctly based on time calibration
signal reception, you need to specify
the area where you are using the
watch.
l
Setting a Home City
Note
●
Areas where time signal reception is
supported are limited. When you are
using the watch in an area where time
calibration signal reception is not
possible, adjust time and day settings
manually.
l
Using Watch Operations to Adjust
the Time Setting
Watch Operation Guide 5678
11
Loading ...
Loading ...
Loading ...