Loading ...
Loading ...
Loading ...
Use To
Parallel Buer
Disabled
Auto
3K to [maximum size allowed]
Set the size of the parallel input buer.
Notes:
• Auto is the factory default setting.
• Disabled turns o job buering. Any print jobs already buered on the
printer hard disk are printed before normal processing resumes.
• The parallel buer size setting can be changed in 1‑KB increments.
• The maximum size allowed depends on the amount of memory in the
printer, the size of the other link buers, and whether Resource Save is
set to On or O.
• To increase the maximum size range for the Parallel Buer, disable or
reduce the size of the USB, serial, and network buers.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Job Buering
O
On
Auto
Temporarily store print jobs on the printer hard disk before printing.
Notes:
• O is the factory default setting.
• On buers print jobs on the printer hard disk.
• Auto buers print jobs only if the printer is busy processing data from
another input port.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Advanced Status
On
O
Enable bidirectional communication through the parallel port.
Notes:
• On is the factory default setting.
• O disables parallel port negotiation.
Protocol
Standard
Fastbytes
Specify the parallel port protocol.
Notes:
• Fastbytes is the factory default setting. It provides compatibility with most
existing parallel ports and is the recommended setting.
• Standard tries to resolve parallel port communication problems.
Honor Init
On
O
Determine if the printer honors printer hardware initialization requests from the
computer.
Notes:
• O is the factory default setting.
• The computer requests initialization by activating the Init signal from the
parallel port. Many personal computers activate the Init signal each time
the computer is turned on.
Parallel Mode 2
On
O
Determine if the parallel port data is sampled on the leading or trailing edge of
a strobe.
Note: On is the factory default setting.
Understanding the printer menus 166
Loading ...
Loading ...
Loading ...