Loading ...
Loading ...
Loading ...
10
BODY AREAS
Women: Legs, arms, underarms, bikini area and face (below the cheek bones)
CAUTION: Do not use the device near the eyes, along the forehead, on the lips or
nostrils. Do not use it in the genital area.
Men: Shoulders and below (chest, back, arms, stomach, legs)
CAUTION: Do not use on the face, neck or genital area.
The device is intended to be used on body hair below the neck, including arms,
underarms, bikini line, stomach and legs.
SKIN COLOR
The device is intended for use on light, medium and dark skin tones up to and including skin tone V (see
Skin tone chart on page 3). The device incorporates two Skin Tone Sensors that measure the color of your
skin and will prevent use if your skin tone is too dark.
HAIR COLOR
The device is intended for use on naturally black or brown hair. It may not be as effective on white, grey,
blonde or red hair.
7 How To Use
WARNING: Follow each step in the treatment process ensuring you complete all aspects of each step
before progressing to the next.
Step 1: Preparing the treatment area
Remove all visible hair on the skin before using the device. You may use your preferred hair removal
method. Remove any cosmetics, lotions and cream from the area you wish to treat. Cleanse the treatment
area and pat dry. To keep the treatment window clean and intact and prevent hair burns, make sure there is
no more hair remaining on the skin surface.
Step 2: Doing a Test Patch
Before your first treatment on each new body area, we RECOMMEND you test your skin (in that area) for
reactions.
The patch test area should be approximately 3 cm x 2 cm in size (equivalent to 2 flashes applied to the skin
side by side). Follow Step 3 to treat the area.
Wait 24 hours following the patch test, to ensure your skin is suitable for treatment and there is no adverse
reaction to the light energy. If there is no reaction after 24 hours, you may treat the area around the test
patch. The ‘patch tested area’ should not be re-treated for at least one week.
Step 3: Treatment
a) Use the mains cord (8) to connect the base station to an electrical outlet. Press any button to activate
the device. The LED power bars (3) will light up once and a fan will start running. This means the device
is in READY mode. During operation, the device will heat up slightly.
b) Press the treatment window (1) firmly against the area to be treated ensuring both skin tone sensors (2)
are in contact with skin. The device will not operate if only one skin tone sensor is in contact with skin.
Once both skin tone sensors measure a valid skin tone, the pre-set output power is displayed on the
LED Power Bars (3) located on both sides of the device.
Silk·expert Pro5 uses skin tone sensors that continuously measure the color (tone) of your skin and
automatically set the correct level of output power needed based on the measured skin tone. This is not
related to the Fitzpatrick skin tone classification. If your skin is too dark for treatment with Silk·expert,
the skin tone sensors will detect this and prevent the unit from operating.
RED lights will be shown in the Power Bar if your skin is too dark.
If a valid skin tone is detected, the Power Bars will illuminate WHITE.
light skin tone U high power setting
dark skin tone U low power setting
90059365_ECLIPSE_PL5_NA.indd 1090059365_ECLIPSE_PL5_NA.indd 10 25.05.21 16:1625.05.21 16:16
Loading ...
Loading ...
Loading ...