Loading ...
Loading ...
Loading ...
1-855-463-4666
34
4. Place LATCH for access to
Rear-facing belt path. Unzip the
pocket to the right side of the latch
storage area, this will allow you to
move the latch connectors down
to the rear-facing belt path. Feed
LATCH anchors down, keeping
it under the cover and out the
bottom. Once completed, close
the zip pocket.
5. Place Car Seat Rear-Facing in
Back Seat of the Vehicle
Place rear-facing in vehicle seat
and center the car seat between
the lower LATCH anchors. The
base should sit fl at on the vehicle
seat.
6. Locate the LATCH Strap in the
Rear-Facing Belt Path.
Thread the LATCH strap through
the rear-facing belt path (marked
with the blue label) and out the
other side. The LATCH belt should
lie fl at and not be twisted.
REAR FACING
6
us.diono.com/welcome
39
FORWARD FACING
FORWARD-FACING INSTALLATIONS:
20-65 lbs (9.1-29.5 kg)
NOTE: IF the child is UNDER 40 Lbs install the
Diono Safe Stop by following the instructions on
page 59 before proceeding.
IMPORTANT: The Safe Stop will need to be
removed once the child reaches 40 lbs.
NOTE: IF the child is OVER 40 LBS, go to Step 1
of Installation using a Shoulder/Lap With 5-Point
Harness
IMPORTANT: IF the child is OVER 25 LBS, lower the
adjustable bottom by following the instructions on
page 40.
NOTE: For Forward-Facing installations using a
LAP BELT ONLY with NO Top Tether anchor point
available, you MUST install the Diono Lap Belt
Cushion by following the instructions on page 60
before proceeding; otherwise go to Step 1 below.
Place car seat forward-facing in the vehicle back
seat. IF the child is over 25 lbs, lower the bottom.
18_Diono_RXT_3_Instructions-MASTER.indd Spread 34 of 36 - Pages(34, 39)18_Diono_RXT_3_Instructions-MASTER.indd Spread 34 of 36 - Pages(34, 39) 21/05/2018 17:0621/05/2018 17:06
Loading ...
Loading ...