Loading ...
Loading ...
Loading ...
37
Care and Cleaning
To clean the surface burner heads
For proper gas flow it may be necessary to clean the burner
head and slots. To clean, first use a clean DAMP cloth to soak up
any spills. Remove any food from between the burner slots using
a small nonabrasive brush like a toothbrush and afterwards
wipe up using a damp cloth. For stubborn soils located in the
slots, use a small-gauge wire or needle to clean.
Any spill on or around the electrode must be carefully cleaned.
Take care not to hit the electrode with any thing hard or it could
be damaged.
To clean the burner head ignition ports
Each burner head has a small ignition port located as illus-
trated. Should you experience ignition problems it may be that
this port hole is partially blocked with soil. With the burner head
in place, use a small wire gauge needle or the end of a paper
clip to clear the ignition port (refer to
Figure 43; round style
shown; oval models on some models not shown).
Important: Always keep the surface burner caps in place
whenever a surface burner is in use.
When replacing the burner caps, be sure the burner caps are
seated firmly on top of the burner heads.
The surface burner heads are secured to the cooktop and must
be cleaned in place on the cooktop. For proper flow of gas and
ignition of burners.
DO NOT allow spills, food, cleaning agents or any other
material to enter the gas orifice holder opening.
Replacing the Oven Light
Be sure the oven is unplugged and all parts are
cool before replacing oven light.
The interior oven lights are located at the rear of the oven cavity
and are covered with a glass shield held by screws. The glass
shield protects the light bulb and must be in place whenever the
oven is in use (
See Figure 44).
To replace the oven interior light bulb:
Be sure the range is unplugged and all parts
are cool before replacing the oven light. Do not allow your
fingers to touch the new bulb when replacing. This will shorten
the life of the bulb. Use a paper towel or cotton glove while
handling the new bulb when installing.
1. Turn electrical power off at the main source.
2. Press the wire holder to one side to release the glass shield
covering the light bulb.
3. Remove interior oven light shield by turning it counter-clock-
wise.
4. Replace bulb with a new halogen bulb.
5. Replace glass oven light shield by rotating clockwise.
6. Turn power back on again at the main source.
7. Be sure to reset the time of day on the clock.
Figure 43: Cooktop burner head
ignition port
slots
Figure 44: Oven light shown in rear corner of oven cavity
Loading ...
Loading ...
Loading ...