Loading ...
Loading ...
Loading ...
19
Gas Conversion and Specifications
Static Oven
1. Carry out the following:-
Remove lower lintel at front of oven.
Open oven door and remove sole plate(s).
Remove main burner.
Disconnect pilot supply tube from pilot burner
to access pilot injector.
2. With Main Burner removed, ensure aeration gap is
adjusted for type of gas being used as shown in ‘Gas
Specifications
Tables’ at end of this section.
3. Remove pilot and main injectors and replace with correct
size injectors as shown in ‘Gas Specifications Tables’ at end
of this section.
4. Refit the following:-
Re-connect pilot supply tube to pilot burner.
Refit main burner and sole plate(s).
Refit lower lintel.
5. To replace low fire screw in static oven gas valve:-
Remove oven control panel.
Remove low fire screw from gas valve and replace with
correct size low fire screw as shown in ‘Gas Specifications
Tables’ at end of this section.
NOTE: The 'Low Fire Screw' should be sealed with coloured
paint on completion of low fire adjustment.
Refit oven control panel.
Burner Adjustment Screw
Main Burner
Main Burner Injector
Pilot Burner
Thermocouple
Aeration Slide
Low Fire Adjustment Screw
Loading ...
Loading ...
Loading ...