Loading ...
Loading ...
Loading ...
QUICK START GUIDE
7
3. Thread water line through back panel hole (with
bushing).
4.
5. Turn on water supply and check for leaks.
6. Reinstall back panel.
CLEAR ICE MACHINES
PREPARE PLUMBING
The water valve uses a standard 1/4” (6.35 mm)
water hook up kit – part # 80-54674-00. The kit includes
3
4
Prior to installation, determine if this product
contains a gravity style drain or factory installed
drain pump. Products without a drain pump may
only use a gravity style drain. Failure to connect
water supply or drain line connections properly
may result in water leakage, personal injury,
and/or property damage. Disconnect power
and turn o water to the unit before attempting
to alter these connections. These connections
are the responsibility of the owner and must be
connected per local plumbing code. If you are
uncertain of how to safely and properly install
this product, contact a licensed plumber.
Water Supply Connection
Connect to potable water supply only.
Review, obey, and understand the local plumbing
codes before you install your unit. Connect to the
cold water supply. The water pressure should
be between 20 and 120 psi (138 and 827 kPa).
The water line MUST have a shut-o valve on the
supply line.
Do not use any plastic water supply line. The line
is under pressure at all times. Plastic may crack
or rupture with age and cause damage to your
home.
Do not use tape or joint compound when
attaching a braided exible water supply line
that includes a rubber gasket. The gasket
provides an adequate seal – other materials
could cause blockage of the valve.
Failure to follow recommendations and
instructions may result in damage and/or harm,
ooding or void the product warranty.
WARNING
!
WARNING
!
CAUTION
!
Loading ...
Loading ...
Loading ...