Loading ...
Loading ...
Loading ...
QUICK START GUIDE
Integrated Panel Installation
1. Fully open door.
2. Starting at corner, pull
gasket away from door.
3. Continue to pull gasket free
from gasket channel.
4.
If the unit has front-mounted hinges, skip ahead
to Step 9.
5. Partially loosen the 3 screws securing the top hinge to
the top of the cabinet.
6. Align the panel with the outside edge (opposite the
hinge) and high enough to align with the highest point
in the door.
7. Insert panel underneath top hinge and apply upward
pressure while bringing the lower portion of the panel
8. Align door with cabinet. Tighten the top 3 screws,
securing the top hinge to the cabinet.
NOTICE
Due to dierences in oor construction or
surrounding cabinetry, the panel may not sit ush
with the top of the door.
9. With panel aligned
to the door, secure
panel to door using
clamps. A robust tape
may also be used.
the use of bar clamps
to secure the panel
to the door. If using
tape, be certain the
tape will not damage
removal.
10. Using a 7/64” (3 mm)
drill bit, drill 6 pilot
holes into the wood
panel 1/2” (12 mm)
deep using the holes
in the door frame as
a guide.
NOTICE
It is important to ensure that all drilled holes are
drilled to the correct depth in order to avoid splits
in the wood when hardwood is installed.
11.
with your unit.
12. Using a Phillips screwdriver, place one screw into each
of the 6 pilot holes and screw down. Do not over-
tighten screws.
13.
channel.
14. Remove clamps from door.
NOTICE
If panel requires additional adjustment after
removing clamps, slightly loosen each screw and
adjust panel as necessary. Tighten screws upon
completion.
15. Starting at the corners, re-install the gasket into the
fully seated.
Integrated Panel
Integrated Panel
u-line.com
Integrated Panel Installation
Door
Panel
Wood
Panel
Door/Drawer
Bar
Clamp
Bar
Clamp
20
Loading ...
Loading ...
Loading ...