Loading ...
Loading ...
Loading ...
en Installation instructions
30
WARNING‒Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use extension cables or multiple
socket strips.
21.2 Appliance dimensions
You will find the dimensions of the appliance here
21.3 Fitted units
This appliance is only intended to be fully fitted in a kit-
chen. It is not intended to be used as a tabletop appli-
ance or within a cupboard.
The fitted cabinet must not have a back panel behind
the appliance. Maintain a clearance of at least 35mm
between the wall and the cabinet base or the rear
panel of the cabinet situated above.
The fitted cabinet must have a ventilation opening of
50cm² on the front. To do this, trim the base panel or
fit a ventilation grille.
Surround units without a ventilation cut-out must have a
ventilation opening measuring 200cm² towards the
rear of the side panels.
Ventilation slots and intake openings must not be
covered.
The mains socket for the appliance must either be loc-
ated in the hatched area or outside of the area
where the appliance is installed.
Any unsecured units must be secured to the wall using
a standard bracket .
21.4 Electrical connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
¡ The appliance corresponds to protection class I and
must only be operated with a protective earth con-
nection.
¡ The fuse protection must correspond to the power
rating specified on the appliance's rating plate and
to the local regulations.
¡ The appliance must be disconnected from the
power supply whenever installation work is being
carried out.
Electrically connecting the appliance with the
protective contact plug
Note:The appliance must only be connected to a pro-
tective contact socket that has been correctly installed.
▶
Insert the mains plug of the appliance into a nearby
socket.
When the appliance is installed, the mains plug of
the power cable must be freely accessible. If free
access to the mains plug is impossible, an all-pole
isolating switch must be integrated into the perman-
ent electrical installation in accordance with the in-
stallation regulations.
Electrically connecting an appliance without a
protective contact plug
Note:Only a licensed professional may connect the ap-
pliance. Damage caused by incorrect connection is not
covered under the warranty.
An all-pole isolating switch must be integrated into the
permanent electrical installation according to the install-
ation regulations.
1.
Identify the phase and neutral conductors in the
socket.
The appliance may be damaged if it is not connec-
ted correctly.
2.
Connect the hob in accordance with the connection
diagram.
See the rating plate for the voltage.
3.
Connect the wires of the mains power cable accord-
ing to the colour coding:
‒ Green/yellow = Protective conductor
‒ Blue = Neutral conductor
‒ Brown = Phase (external conductor)
21.5 Installation below a worktop
Observe the installation dimensions and the safety
clearances when installing below a worktop.
Loading ...
Loading ...
Loading ...