Loading ...
Loading ...
Loading ...
Setting Surface ControMs
Each burner lights automatically from an electric: ignitor each time a control knob isturned to
the lite position.
To operate the surface burner:
1. Placecooking utensil on burner.
2. Push in and turn tile Surface Control knob to LITE.Note: All electronic: ignitors will click
at the same time. However, only the burner you are turning on will ignite.
3. Visually check that the burner has lit.
4. After the burner lights, turn the control knob to the desired flame size.The control knobs
do not haveto be set at a particular mark. Use the guides and adjust the flame asneeded.
DO NOT cook with the control knob in the LITE position. (Tile electronic ignitor will
continue to click if left in the LITEposition.)
5. Toturn the burner off, turn the control knob asfar as it ill go, to tile OFFposition.
The surface control knobs
shown below may not look iden-
tical to the Surface Controls
Knobs on your range; They are
only representational
OFF
reed
In the event of an electrical power outage, the surface burners can be lit manually. To light a
surface burner, hold a lit match to the burner head, then slowly turn the surface control knob to
LITE.Use caution when lighting surface burners manually.
Surface burner in usewhen an electrical power failure occurs will continue to operate normally.
Do not operate the burner for an extended period of time without cookware on the grate. Tile finish on
the grate may chip without cookware to absorb tile heat.
Do not place plastic items such as salt and pepper shakers, spoon hotders or plastic wrappings on top
of the cooktop when it is in use, Theseitems could melt or ignite. Pot holders, towels or wood spoons could catch fire if placed
too close to a flame.
Before Setting Oven ControMs
Some modets are equipped with a blower which runs in baking and self-cleaning mode to keep
a[[ internal components at a coo[ temperature. It is possible that the blower keeps running even if the range has
been turned off, untit the components have cooled down.
Oven Vent Location
The oven is vented at the rear of tile cooktop. When the oven is on, warm air is released through the vents. This venting is
necessary for proper air circulation in the oven and good baking results. DO NOT block the vents. Doing so may cause cooking
failures, fire or damage to the appliance
Arranging Oven Racks
ALWAYSARRANGEOVENRACKSWHEN THEOVENISCOOL(PRIORTO OPERATING
THE OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack
and slide out,
To replace an oven rack, Fit the rack onto the guides on the oven walls. Tilt the
front of the rack upward and slide the rack back into place.
/
Setting Oven ControMs
For oven settings, refer to the time or the electronic oven control section.
Loading ...
Loading ...
Loading ...