Loading ...
Loading ...
Loading ...
Avoid Service CheckMist ( ont n.ed)
PROBLEM POSSIBLECAUSE/SOLUTION
CERAMIC GLASS COOKTOP (some models)
Scratches or abrasions on cooktop Coarse particles such as salt or sand between cooktop and utensils (:an cause scratches. Be
surface, sure cooktop surface and bottoms of utensils are (:leanbefore usage. Smallscratches do not
affect cooking and will become lessvisible with time.
Cleaning materials not recommended for ceramic-glass cooktop have been used. See
"Ceramic-Glass Cooktop Cleaning" in the General Cleaning section.
Cookware with rough bottom has been used. Usesmooth, flat-bottomed cookware.
Metal marks. Sliding or scraping of metal utensils on cooktop surface. Do not slide metal utensils on
cooktop surface. Use a ceramic-glass cooktop cleaning creme to remove the marks. See
"Ceramic-Glass Cooktop Cleaning" in the General Cleaning section.
Brown streaks or specks. Boilovers are cooked onto surface. Use razor blade scraper to remove soil. See "Ceramic-
GlassCooktop Cleaning" in the General Cleaning section.
Areas of discoloration with metal- Mineral deposits from water and food. Remove using a ceramic-glass cooktop cleaning
lic sheen, creme. Use cookware with clean, dry bottoms.
GAS BURNERS COOKTOP (some models)
Surface burners do not light. Surfa(e control knob has not been completely turned to LITE.Push in and turn the surface
control knob to LITE(until burner ignites) and then turn the surface control knob to the
desired flame size.
Burner ports are clogged. Clean burners. See "To Clean the Burner Grates, Contoured
Burner Pans, Burner Cap Assembly, Trim Ring and Burner Base" under General Cleaning.
With the burner off, use small-gauge wire or needle to clean ports or slots.
Electrical power outage (Electric Ignition models only), Check house lights to be sure. Call
your local electric company for service. Surface burners can be lit manually. See Setting
Surface Controls in this Owner's Guide.
Gassupply isturned off. Turn gas supply on.
Surface burner flame burns half Burner ports or slots are clogged. With the burner off, clean by using a small-gauge wire or
way around, needle to clean ports or slots.
Moisture is present after cleaning. Lightly fan the flame and allow the burner to operate
until flame is full. Dry tile burners thoroughly following instructions under General
Cleaning.
Surface burner flame isorange. Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.
Salt air in coastal areas. A slightly orange flame is unavoidable.
21
Loading ...
Loading ...
Loading ...