Loading ...
Loading ...
Loading ...
Genera[ Cleaning (continued)
Storage Drawer (some modeJs)
Use the storage drawer for storing cooking utensils. The drawer can de removed to facilitate cleaning under the range. Use care
when handling the drawer.
Toopen the storage drawer, push the drawer in gently and it will spring open. Toclose, push the drawer until you hear a click,
which indicates that the spring is compressed, and the drawer isclosed.
Frame
Storage
Drawer
To remove the drawer:
1. Pull empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over tile rollers.
To replace the drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Pushthe drawer in LJntilit stops, then lift to allow the rollers to clearthe roller guide stop,
and push in.
Changing Oven Light
Be surethe oven is unplugged and all parts are COOL before replacing tile oven light bulb. Do not turn tile oven
light on during the self-cleaning cycle. High temperature will reduce lamp life.
On some models an interior oven light will turn on automatically when tile oven door isopened.
The oven light may be turned on when the door is closed by using the oven light switch located on tile control panel.
On a self clean oven tile lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACEWHENEVER THE OVEN tS tN USE.
To replace the light bulb:
CAUTION: BE SUREOVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 watt appliance bulb only.
4. Forself-cleaning oven, presswire holder to one side to release glass shield, change bulb and be
sureto replace glass shield.
Avoid Service Checklist
Before you call for service oread this
You may savethe cost and inconvenience of an unnecessary servicecall byfirst reviewing this easyto useAvoid-Service Check List
of the most frequently encountered situations that are not tile result of defective workmanship of materials.
You will be charged for a service call while the appliance is in warranty if the problem is not caused by defective product
workmanship or materials.
Your new appliance isa carefully engineered product. Many times, what appears to be a reason to call for servicerequires nothing
more than a simple adjustment you can easily make in your own home or is normal operating characteristic of appliance under
certain conditions.
This list isapplicable to a variety of models; some of the items will not necessarily apply to your appliance.
PROBLEM POSSIBLECAUSE/SOLUTION
INSTALLATION
Range is not level. Poor installation. Placeoven rack in center of oven. Adjust leveling legs (slideqn models) at
base of range until the oven rack is level.
Be sure floor islevel and isstrong and stable enough to adequately support range.
19
Loading ...
Loading ...
Loading ...