Loading ...
Loading ...
Loading ...
GB
21
BASIC OPERATION GUIDE
1 After putting through the power, press “ON/OFF” button or remote controller to turn
on the air conditioner. Press it again to turn it off.
2 Press “MODE” button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3 Press “
” or “ ” button to set your required temperature. Temperature cannot be
adjusted under auto mode.
4 Press “FAN” button to set your required fan speed: auto, low speed, low-medium
speed, medium speed, medium-high speed, high speed.
5 Press button to select fan blowing angle.
REPLACEMENT OF BATTERIES IN REMOTE CONTROLLER
1. Press the back side of remote controller marked
with “OPEN” and then push out the
cover of battery box along the arrow direction.
2. Replace two 7# {AAA 1.5V) dry batteries, and
make sure the position of “+” and “-” polar
are correct.
3. Reinstall the cover of battery box.
NOTE:
• During operation, point the remote control signal sender at the receiving window on
indoor unit.
• The distance between signal sender and receiving window should be no more than 8m,
and there should be no obstacles between them.
• Signal may be interfered easily in the room where there is fluorescent lamp or wireless
telephone; remote controller should be close to indoor unit during operation.
• Replace new batteries of the same model when replacement is required.
• When you don’t use remote controller for a long time, please take out the batteries.
• lf the display on remote controller is fuzzy or there’s no display, please replace batteries.
Signal sender Batteries
Reinstall
Remove
Cover off battery box
Loading ...
Loading ...
Loading ...