S77-2011 Sole treadmill - may 2012

User Manual - Page 30

For S77-2011.

PDF File Manual, 32 pages, Download pdf file

Loading ...
Loading ...
Loading ...
SERVICEECKLIST-DIAGNOSISGUI E
Before contacting your dealer for aid, please review the following information. It may save you
both time and expense.This list includes common problems that may not be covered under the
treadmill's warranty.
PROBLEM SOLUTION/CAUSE
Display does not light
Tread=belt does not stay centered
Treadmill belt hesitates when
walked/run on
Motor is not responsive after
pressing start
Treadmill will only achieve
approximately 7 mph but shows
higher speed on display
1. Tether cord not in position.
2. Circuit breaker on front grill tripped.
Push circuit breaker in until it locks.
3. Plug is disconnected. Make sure plug is firmly
pushed into AC household wall outlet.
4. Household circuit breaker may be tripped.
5. Treadmill defect. Contact your SOLE dealer.
The user may be walking while favoring or putting
more weight on either the left or right foot. If this
walking pattern is natural, track the belt slightly
off-center to the side opposite from the belt
movement. SeeGeneral Maintenance section on
Tread-belt Tension. Adjust as necessary.
1. If the belt moves, but stops after a short time and
thedisplay shows"LS", run calibration.
2. If you press start and the belt never moves, then
the display shows LS,contact service.
This indicates motor should be receiving power to
operate. Low AC voltage to treadmill. Do not use an
extension cord. If an extension cord is required it
should be as short as possible and heavy duty 16
gauge minimum. Low household voltage. Contact an
electrician or your SOLE dealer. A minimum of 110 volt
AC current is required.
Tread-belt stops quickly/suddenly High belt/deck friction. See General Maintenance
when tether cord is pulled section on lubrication.
Treadmill trips on board 15 amp circuit
Computer shuts off when console is
touched (on a cold day) while
walking/running
High belt/deck friction. See General Maintenance
Treadmill may not be grounded. Static electricity is
"crashing'the computer. Refer to Grounding
Instructions on page 4.
House circuit breaker trips, but not Need to replace the house breaker with a "High In-
the treadmill circuit breaker rush current"type breaker (see page 4 for details)
$77 TREADMILL 28
Loading ...
Loading ...